ASoC: Remove incorrect WM8903 erratum workaround
Due to a typographical error in the erratum workaround it was never
functional so just remove it.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: Liam Girdwood <lrg@slimlogic.co.uk>
diff --git a/sound/soc/codecs/wm8903.c b/sound/soc/codecs/wm8903.c
index 02de5ae..b9843f7 100644
--- a/sound/soc/codecs/wm8903.c
+++ b/sound/soc/codecs/wm8903.c
@@ -1014,7 +1014,7 @@
static int wm8903_set_bias_level(struct snd_soc_codec *codec,
enum snd_soc_bias_level level)
{
- u16 reg, reg2;
+ u16 reg;
switch (level) {
case SND_SOC_BIAS_ON:
@@ -1038,23 +1038,15 @@
wm8903_run_sequence(codec, 0);
wm8903_sync_reg_cache(codec, codec->reg_cache);
- /* Enable low impedence charge pump output */
- reg = snd_soc_read(codec,
- WM8903_CONTROL_INTERFACE_TEST_1);
- snd_soc_write(codec, WM8903_CONTROL_INTERFACE_TEST_1,
- reg | WM8903_TEST_KEY);
- reg2 = snd_soc_read(codec, WM8903_CHARGE_PUMP_TEST_1);
- snd_soc_write(codec, WM8903_CHARGE_PUMP_TEST_1,
- reg2 | WM8903_CP_SW_KELVIN_MODE_MASK);
- snd_soc_write(codec, WM8903_CONTROL_INTERFACE_TEST_1,
- reg);
-
/* By default no bypass paths are enabled so
* enable Class W support.
*/
dev_dbg(codec->dev, "Enabling Class W\n");
- snd_soc_write(codec, WM8903_CLASS_W_0, reg |
- WM8903_CP_DYN_FREQ | WM8903_CP_DYN_V);
+ snd_soc_update_bits(codec, WM8903_CLASS_W_0,
+ WM8903_CP_DYN_FREQ |
+ WM8903_CP_DYN_V,
+ WM8903_CP_DYN_FREQ |
+ WM8903_CP_DYN_V);
}
reg = snd_soc_read(codec, WM8903_VMID_CONTROL_0);