ath10k: make monitor vdev down before stoping it
Following sequence causes FW crash:
-monitor vdev up,
-monitor vdev stop,
-monitor vdev delete.
Making monitor vdev down before stoping it works ok:
-monitor vdev up,
-monitor vdev down,
-monitor vdev stop,
-monitor vdev delete.
Signed-off-by: Marek Puzyniak <marek.puzyniak@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index 99a9bad..df4d299 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -562,12 +562,9 @@
lockdep_assert_held(&ar->conf_mutex);
- /* For some reasons, ath10k_wmi_vdev_down() here couse
- * often ath10k_wmi_vdev_stop() to fail. Next we could
- * not run monitor vdev and driver reload
- * required. Don't see such problems we skip
- * ath10k_wmi_vdev_down() here.
- */
+ ret = ath10k_wmi_vdev_down(ar, ar->monitor_vdev_id);
+ if (ret)
+ ath10k_warn("Monitor vdev down failed: %d\n", ret);
ret = ath10k_wmi_vdev_stop(ar, ar->monitor_vdev_id);
if (ret)