spi: sh-msiof: Configure DMA slave bus width
The new Renesas R-Car Gen2 DMA Controller driver (rcar-dmac) requires
explicit configuration of the DMA slave bus width.
Hardcode the DMA transfer size to 4 bytes, as MSIOF DMA is limited to
32-bit words.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi-sh-msiof.c b/drivers/spi/spi-sh-msiof.c
index 887c208..b19cbb4 100644
--- a/drivers/spi/spi-sh-msiof.c
+++ b/drivers/spi/spi-sh-msiof.c
@@ -987,10 +987,13 @@
memset(&cfg, 0, sizeof(cfg));
cfg.slave_id = id;
cfg.direction = dir;
- if (dir == DMA_MEM_TO_DEV)
+ if (dir == DMA_MEM_TO_DEV) {
cfg.dst_addr = port_addr;
- else
+ cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
+ } else {
cfg.src_addr = port_addr;
+ cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
+ }
ret = dmaengine_slave_config(chan, &cfg);
if (ret) {