powerpc/fsl: Setup PCI inbound window based on actual amount of memory
Previouslly we just always set the inbound window to 2G. This was
broken for systems with >2G. If a system has >=4G we will need
SWIOTLB support to handle that case.
We now allocate PCICSRBAR/PEXCSRBAR right below the lowest PCI outbound
address for MMIO or the 4G boundary (if the lowest PCI address is above
4G).
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/sysdev/fsl_pci.h b/arch/powerpc/sysdev/fsl_pci.h
index 13f30c2..a9d8bbe 100644
--- a/arch/powerpc/sysdev/fsl_pci.h
+++ b/arch/powerpc/sysdev/fsl_pci.h
@@ -16,7 +16,11 @@
#define PCIE_LTSSM 0x0404 /* PCIE Link Training and Status */
#define PCIE_LTSSM_L0 0x16 /* L0 state */
-#define PIWAR_2G 0xa0f5501e /* Enable, Prefetch, Local Mem, Snoop R/W, 2G */
+#define PIWAR_EN 0x80000000 /* Enable */
+#define PIWAR_PF 0x20000000 /* prefetch */
+#define PIWAR_TGI_LOCAL 0x00f00000 /* target - local memory */
+#define PIWAR_READ_SNOOP 0x00050000
+#define PIWAR_WRITE_SNOOP 0x00005000
/* PCI/PCI Express outbound window reg */
struct pci_outbound_window_regs {