b43: LP-PHY: Two small spec updates
The specs are beginning to support rev3 LP-PHYs - implement one of
the changes needed for rev3 support.
Also, in the new MIPS driver, the "Japan TX filter" was renamed to
"analog TX filter init" - however, calling it "init" is confusing,
so name it "set analog filter", with a comment for easier future
identification.
Signed-off-by: Gábor Stefanik <netrolller.3d@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/b43/phy_lp.c b/drivers/net/wireless/b43/phy_lp.c
index 9402383..37ba177 100644
--- a/drivers/net/wireless/b43/phy_lp.c
+++ b/drivers/net/wireless/b43/phy_lp.c
@@ -609,9 +609,14 @@
b43_radio_write(dev, B2063_PA_SP7, 0);
b43_radio_write(dev, B2063_TX_RF_SP6, 0x20);
b43_radio_write(dev, B2063_TX_RF_SP9, 0x40);
- b43_radio_write(dev, B2063_PA_SP3, 0xa0);
- b43_radio_write(dev, B2063_PA_SP4, 0xa0);
- b43_radio_write(dev, B2063_PA_SP2, 0x18);
+ if (dev->phy.rev == 2) {
+ b43_radio_write(dev, B2063_PA_SP3, 0xa0);
+ b43_radio_write(dev, B2063_PA_SP4, 0xa0);
+ b43_radio_write(dev, B2063_PA_SP2, 0x18);
+ } else {
+ b43_radio_write(dev, B2063_PA_SP3, 0x20);
+ b43_radio_write(dev, B2063_PA_SP2, 0x20);
+ }
}
struct lpphy_stx_table_entry {
@@ -1972,7 +1977,9 @@
return err;
}
-static void lpphy_japan_filter(struct b43_wldev *dev, int channel)
+
+/* This was previously called lpphy_japan_filter */
+static void lpphy_set_analog_filter(struct b43_wldev *dev, int channel)
{
struct b43_phy_lp *lpphy = dev->phy.lp;
u16 tmp = (channel == 14); //SPEC FIXME check japanwidefilter!
@@ -2141,7 +2148,7 @@
err = lpphy_b2062_tune(dev, new_channel);
if (err)
return err;
- lpphy_japan_filter(dev, new_channel);
+ lpphy_set_analog_filter(dev, new_channel);
lpphy_adjust_gain_table(dev, channel2freq_lp(new_channel));
}