regulator: Add soft start support
Some regulators support a "soft start" feature where the voltage
ramps up slowly when the regulator is enabled. Add an op
(set_soft_start) and a DT property + constraint to support this.
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h
index 76144a3..e0635d0 100644
--- a/include/linux/regulator/driver.h
+++ b/include/linux/regulator/driver.h
@@ -161,6 +161,8 @@
unsigned int old_selector,
unsigned int new_selector);
+ int (*set_soft_start) (struct regulator_dev *);
+
/* report regulator status ... most other accessors report
* control inputs, this reports results of combining inputs
* from Linux (and other sources) with the actual load.
diff --git a/include/linux/regulator/machine.h b/include/linux/regulator/machine.h
index 8ffb061..7f7d0a3 100644
--- a/include/linux/regulator/machine.h
+++ b/include/linux/regulator/machine.h
@@ -142,6 +142,7 @@
unsigned boot_on:1; /* bootloader/firmware enabled regulator */
unsigned apply_uV:1; /* apply uV constraint if min == max */
unsigned ramp_disable:1; /* disable ramp delay */
+ unsigned soft_start:1; /* ramp voltage slowly */
unsigned pull_down:1; /* pull down resistor when regulator off */
};