usb: chipidea: fix nobody cared IRQ when booting with host role
If we connect Male-A-To-Male-A cable between otg-host and host pc,
the ci->vbus_active is set wrongly, and cause the controller run
at peripheral mode when we load gadget module (ci_udc_start will be run),
but the software runs at host mode due to id = 0. The ehci_irq
can't handle suspend (USBi_SLI) interrupt which is enabled for
peripheral mode, it causes no one will handle irq error.
This patch is needed for 3.12 stable
Cc: stable <stable@vger.kernel.org>
Acked-by: Michael Grzeschik <mgr@pengutronix.de>
Reported-by: Marc Kleine-Budde <mkl@pengutronix.de>
Tested-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: Peter Chen <peter.chen@freescale.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
index 5d8981c..6e73f8c 100644
--- a/drivers/usb/chipidea/core.c
+++ b/drivers/usb/chipidea/core.c
@@ -642,6 +642,10 @@
: CI_ROLE_GADGET;
}
+ /* only update vbus status for peripheral */
+ if (ci->role == CI_ROLE_GADGET)
+ ci_handle_vbus_change(ci);
+
ret = ci_role_start(ci, ci->role);
if (ret) {
dev_err(dev, "can't start %s role\n", ci_role(ci)->name);
diff --git a/drivers/usb/chipidea/udc.c b/drivers/usb/chipidea/udc.c
index b34c819..69d20fb 100644
--- a/drivers/usb/chipidea/udc.c
+++ b/drivers/usb/chipidea/udc.c
@@ -1795,9 +1795,6 @@
pm_runtime_no_callbacks(&ci->gadget.dev);
pm_runtime_enable(&ci->gadget.dev);
- /* Update ci->vbus_active */
- ci_handle_vbus_change(ci);
-
return retval;
destroy_eps: