ARM: OMAP2+: omap-usb-host: Add usbhs_init_phys()
This helper allows board support code to add the PHY's
VCC and RESET regulators which are GPIO controlled as well
as the NOP PHY device.
Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/usb.h b/arch/arm/mach-omap2/usb.h
index 3319f5c..e7261eb 100644
--- a/arch/arm/mach-omap2/usb.h
+++ b/arch/arm/mach-omap2/usb.h
@@ -53,8 +53,17 @@
#define USBPHY_OTGSESSEND_EN (1 << 20)
#define USBPHY_DATA_POLARITY (1 << 23)
+struct usbhs_phy_data {
+ int port; /* 1 indexed port number */
+ int reset_gpio;
+ int vcc_gpio;
+ bool vcc_polarity; /* 1 active high, 0 active low */
+ void *platform_data;
+};
+
extern void usb_musb_init(struct omap_musb_board_data *board_data);
extern void usbhs_init(struct usbhs_omap_platform_data *pdata);
+extern int usbhs_init_phys(struct usbhs_phy_data *phy, int num_phys);
extern void am35x_musb_reset(void);
extern void am35x_musb_phy_power(u8 on);