IB/ehca: SRQ fixes to enable IPoIB CM
Fix ehca SRQ support so that IPoIB connected mode works:
- Report max_srq > 0 if SRQ is supported
- Report "last wqe reached" asynchronous event when base QP dies;
this is required by the IB spec and IPoIB CM relies on receiving it
when cleaning up.
Signed-off-by: Joachim Fenkes <fenkes@de.ibm.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ehca/ehca_hca.c b/drivers/infiniband/hw/ehca/ehca_hca.c
index fc19ef9..cf22472 100644
--- a/drivers/infiniband/hw/ehca/ehca_hca.c
+++ b/drivers/infiniband/hw/ehca/ehca_hca.c
@@ -93,9 +93,13 @@
props->max_pd = min_t(int, rblock->max_pd, INT_MAX);
props->max_ah = min_t(int, rblock->max_ah, INT_MAX);
props->max_fmr = min_t(int, rblock->max_mr, INT_MAX);
- props->max_srq = 0;
- props->max_srq_wr = 0;
- props->max_srq_sge = 0;
+
+ if (EHCA_BMASK_GET(HCA_CAP_SRQ, shca->hca_cap)) {
+ props->max_srq = props->max_qp;
+ props->max_srq_wr = props->max_qp_wr;
+ props->max_srq_sge = 3;
+ }
+
props->max_pkeys = 16;
props->local_ca_ack_delay
= rblock->local_ca_ack_delay;