[PATCH] Add rtl8187 wireless driver
This patch adds a mac80211 based wireless driver for the rtl8187 USB
wireless card.
Signed-off-by: Michael Wu <flamingice@sourmilk.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rtl818x.h b/drivers/net/wireless/rtl818x.h
new file mode 100644
index 0000000..e4ee946
--- /dev/null
+++ b/drivers/net/wireless/rtl818x.h
@@ -0,0 +1,212 @@
+#ifndef RTL818X_H
+#define RTL818X_H
+
+struct rtl818x_csr {
+ u8 MAC[6];
+ u8 reserved_0[2];
+ __le32 MAR[2];
+ u8 RX_FIFO_COUNT;
+ u8 reserved_1;
+ u8 TX_FIFO_COUNT;
+ u8 BQREQ;
+ u8 reserved_2[4];
+ __le32 TSFT[2];
+ __le32 TLPDA;
+ __le32 TNPDA;
+ __le32 THPDA;
+ __le16 BRSR;
+ u8 BSSID[6];
+ u8 RESP_RATE;
+ u8 EIFS;
+ u8 reserved_3[1];
+ u8 CMD;
+#define RTL818X_CMD_TX_ENABLE (1 << 2)
+#define RTL818X_CMD_RX_ENABLE (1 << 3)
+#define RTL818X_CMD_RESET (1 << 4)
+ u8 reserved_4[4];
+ __le16 INT_MASK;
+ __le16 INT_STATUS;
+#define RTL818X_INT_RX_OK (1 << 0)
+#define RTL818X_INT_RX_ERR (1 << 1)
+#define RTL818X_INT_TXL_OK (1 << 2)
+#define RTL818X_INT_TXL_ERR (1 << 3)
+#define RTL818X_INT_RX_DU (1 << 4)
+#define RTL818X_INT_RX_FO (1 << 5)
+#define RTL818X_INT_TXN_OK (1 << 6)
+#define RTL818X_INT_TXN_ERR (1 << 7)
+#define RTL818X_INT_TXH_OK (1 << 8)
+#define RTL818X_INT_TXH_ERR (1 << 9)
+#define RTL818X_INT_TXB_OK (1 << 10)
+#define RTL818X_INT_TXB_ERR (1 << 11)
+#define RTL818X_INT_ATIM (1 << 12)
+#define RTL818X_INT_BEACON (1 << 13)
+#define RTL818X_INT_TIME_OUT (1 << 14)
+#define RTL818X_INT_TX_FO (1 << 15)
+ __le32 TX_CONF;
+#define RTL818X_TX_CONF_LOOPBACK_MAC (1 << 17)
+#define RTL818X_TX_CONF_NO_ICV (1 << 19)
+#define RTL818X_TX_CONF_DISCW (1 << 20)
+#define RTL818X_TX_CONF_R8180_ABCD (2 << 25)
+#define RTL818X_TX_CONF_R8180_F (3 << 25)
+#define RTL818X_TX_CONF_R8185_ABC (4 << 25)
+#define RTL818X_TX_CONF_R8185_D (5 << 25)
+#define RTL818X_TX_CONF_HWVER_MASK (7 << 25)
+#define RTL818X_TX_CONF_CW_MIN (1 << 31)
+ __le32 RX_CONF;
+#define RTL818X_RX_CONF_MONITOR (1 << 0)
+#define RTL818X_RX_CONF_NICMAC (1 << 1)
+#define RTL818X_RX_CONF_MULTICAST (1 << 2)
+#define RTL818X_RX_CONF_BROADCAST (1 << 3)
+#define RTL818X_RX_CONF_DATA (1 << 18)
+#define RTL818X_RX_CONF_CTRL (1 << 19)
+#define RTL818X_RX_CONF_MGMT (1 << 20)
+#define RTL818X_RX_CONF_BSSID (1 << 23)
+#define RTL818X_RX_CONF_RX_AUTORESETPHY (1 << 28)
+#define RTL818X_RX_CONF_ONLYERLPKT (1 << 31)
+ __le32 INT_TIMEOUT;
+ __le32 TBDA;
+ u8 EEPROM_CMD;
+#define RTL818X_EEPROM_CMD_READ (1 << 0)
+#define RTL818X_EEPROM_CMD_WRITE (1 << 1)
+#define RTL818X_EEPROM_CMD_CK (1 << 2)
+#define RTL818X_EEPROM_CMD_CS (1 << 3)
+#define RTL818X_EEPROM_CMD_NORMAL (0 << 6)
+#define RTL818X_EEPROM_CMD_LOAD (1 << 6)
+#define RTL818X_EEPROM_CMD_PROGRAM (2 << 6)
+#define RTL818X_EEPROM_CMD_CONFIG (3 << 6)
+ u8 CONFIG0;
+ u8 CONFIG1;
+ u8 CONFIG2;
+ __le32 ANAPARAM;
+ u8 MSR;
+#define RTL818X_MSR_NO_LINK (0 << 2)
+#define RTL818X_MSR_ADHOC (1 << 2)
+#define RTL818X_MSR_INFRA (2 << 2)
+ u8 CONFIG3;
+#define RTL818X_CONFIG3_ANAPARAM_WRITE (1 << 6)
+ u8 CONFIG4;
+#define RTL818X_CONFIG4_POWEROFF (1 << 6)
+#define RTL818X_CONFIG4_VCOOFF (1 << 7)
+ u8 TESTR;
+ u8 reserved_9[2];
+ __le16 PGSELECT;
+ __le32 ANAPARAM2;
+ u8 reserved_10[12];
+ __le16 BEACON_INTERVAL;
+ __le16 ATIM_WND;
+ __le16 BEACON_INTERVAL_TIME;
+ __le16 ATIMTR_INTERVAL;
+ u8 reserved_11[4];
+ u8 PHY[4];
+ __le16 RFPinsOutput;
+ __le16 RFPinsEnable;
+ __le16 RFPinsSelect;
+ __le16 RFPinsInput;
+ __le32 RF_PARA;
+ __le32 RF_TIMING;
+ u8 GP_ENABLE;
+ u8 GPIO;
+ u8 reserved_12[10];
+ u8 TX_AGC_CTL;
+#define RTL818X_TX_AGC_CTL_PERPACKET_GAIN_SHIFT (1 << 0)
+#define RTL818X_TX_AGC_CTL_PERPACKET_ANTSEL_SHIFT (1 << 1)
+#define RTL818X_TX_AGC_CTL_FEEDBACK_ANT (1 << 2)
+ u8 TX_GAIN_CCK;
+ u8 TX_GAIN_OFDM;
+ u8 TX_ANTENNA;
+ u8 reserved_13[16];
+ u8 WPA_CONF;
+ u8 reserved_14[3];
+ u8 SIFS;
+ u8 DIFS;
+ u8 SLOT;
+ u8 reserved_15[5];
+ u8 CW_CONF;
+#define RTL818X_CW_CONF_PERPACKET_CW_SHIFT (1 << 0)
+#define RTL818X_CW_CONF_PERPACKET_RETRY_SHIFT (1 << 1)
+ u8 CW_VAL;
+ u8 RATE_FALLBACK;
+ u8 reserved_16[25];
+ u8 CONFIG5;
+ u8 TX_DMA_POLLING;
+ u8 reserved_17[2];
+ __le16 CWR;
+ u8 RETRY_CTR;
+ u8 reserved_18[5];
+ __le32 RDSAR;
+ u8 reserved_19[18];
+ u16 TALLY_CNT;
+ u8 TALLY_SEL;
+} __attribute__((packed));
+
+static const struct ieee80211_rate rtl818x_rates[] = {
+ { .rate = 10,
+ .val = 0,
+ .flags = IEEE80211_RATE_CCK },
+ { .rate = 20,
+ .val = 1,
+ .flags = IEEE80211_RATE_CCK },
+ { .rate = 55,
+ .val = 2,
+ .flags = IEEE80211_RATE_CCK },
+ { .rate = 110,
+ .val = 3,
+ .flags = IEEE80211_RATE_CCK },
+ { .rate = 60,
+ .val = 4,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 90,
+ .val = 5,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 120,
+ .val = 6,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 180,
+ .val = 7,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 240,
+ .val = 8,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 360,
+ .val = 9,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 480,
+ .val = 10,
+ .flags = IEEE80211_RATE_OFDM },
+ { .rate = 540,
+ .val = 11,
+ .flags = IEEE80211_RATE_OFDM },
+};
+
+static const struct ieee80211_channel rtl818x_channels[] = {
+ { .chan = 1,
+ .freq = 2412},
+ { .chan = 2,
+ .freq = 2417},
+ { .chan = 3,
+ .freq = 2422},
+ { .chan = 4,
+ .freq = 2427},
+ { .chan = 5,
+ .freq = 2432},
+ { .chan = 6,
+ .freq = 2437},
+ { .chan = 7,
+ .freq = 2442},
+ { .chan = 8,
+ .freq = 2447},
+ { .chan = 9,
+ .freq = 2452},
+ { .chan = 10,
+ .freq = 2457},
+ { .chan = 11,
+ .freq = 2462},
+ { .chan = 12,
+ .freq = 2467},
+ { .chan = 13,
+ .freq = 2472},
+ { .chan = 14,
+ .freq = 2484}
+};
+
+#endif /* RTL818X_H */