fm10k: use ether_addr_equal instead of memcmp
When comparing MAC addresses, use ether_addr_equal instead of memcmp to
ETH_ALEN length. Found and replaced using the following sed:
sed -e 's/memcmp\x28\(.*\), ETH_ALEN\x29/!ether_addr_equal\x28\1\x29/'
Reported-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
Reviewed-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Krishneil Singh <Krishneil.k.singh@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/fm10k/fm10k_tlv.c b/drivers/net/ethernet/intel/fm10k/fm10k_tlv.c
index 95afb5c..ab01bb3 100644
--- a/drivers/net/ethernet/intel/fm10k/fm10k_tlv.c
+++ b/drivers/net/ethernet/intel/fm10k/fm10k_tlv.c
@@ -755,7 +755,7 @@
err = fm10k_tlv_attr_get_mac_vlan(
results[FM10K_TEST_MSG_MAC_ADDR],
result_mac, &result_vlan);
- if (!err && memcmp(test_mac, result_mac, ETH_ALEN))
+ if (!err && !ether_addr_equal(test_mac, result_mac))
err = FM10K_ERR_INVALID_VALUE;
if (!err && test_vlan != result_vlan)
err = FM10K_ERR_INVALID_VALUE;