fm10k: use ether_addr_equal instead of memcmp
When comparing MAC addresses, use ether_addr_equal instead of memcmp to
ETH_ALEN length. Found and replaced using the following sed:
sed -e 's/memcmp\x28\(.*\), ETH_ALEN\x29/!ether_addr_equal\x28\1\x29/'
Reported-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
Reviewed-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Krishneil Singh <Krishneil.k.singh@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/fm10k/fm10k_vf.c b/drivers/net/ethernet/intel/fm10k/fm10k_vf.c
index 5445c0f..f1dc6e8 100644
--- a/drivers/net/ethernet/intel/fm10k/fm10k_vf.c
+++ b/drivers/net/ethernet/intel/fm10k/fm10k_vf.c
@@ -298,7 +298,7 @@
/* verify we are not locked down on the MAC address */
if (is_valid_ether_addr(hw->mac.perm_addr) &&
- memcmp(hw->mac.perm_addr, mac, ETH_ALEN))
+ !ether_addr_equal(hw->mac.perm_addr, mac))
return FM10K_ERR_PARAM;
/* add bit to notify us if this is a set or clear operation */