cxgb4: Fixed the code to use correct length for part number
Previously it was using the length value of serial number.
Also added macro for VPD unique identifier (0x82).
Signed-off-by: Casey Leedom <leedom@chelsio.com>
Signed-off-by: Hariprasad Shenai <hariprasad@chelsio.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/chelsio/cxgb4/t4_hw.c b/drivers/net/ethernet/chelsio/cxgb4/t4_hw.c
index 6b92c4c..adf16a5 100644
--- a/drivers/net/ethernet/chelsio/cxgb4/t4_hw.c
+++ b/drivers/net/ethernet/chelsio/cxgb4/t4_hw.c
@@ -566,6 +566,7 @@
#define VPD_BASE 0x400
#define VPD_BASE_OLD 0
#define VPD_LEN 1024
+#define CHELSIO_VPD_UNIQUE_ID 0x82
/**
* t4_seeprom_wp - enable/disable EEPROM write protection
@@ -603,7 +604,14 @@
ret = pci_read_vpd(adapter->pdev, VPD_BASE, sizeof(u32), vpd);
if (ret < 0)
goto out;
- addr = *vpd == 0x82 ? VPD_BASE : VPD_BASE_OLD;
+
+ /* The VPD shall have a unique identifier specified by the PCI SIG.
+ * For chelsio adapters, the identifier is 0x82. The first byte of a VPD
+ * shall be CHELSIO_VPD_UNIQUE_ID (0x82). The VPD programming software
+ * is expected to automatically put this entry at the
+ * beginning of the VPD.
+ */
+ addr = *vpd == CHELSIO_VPD_UNIQUE_ID ? VPD_BASE : VPD_BASE_OLD;
ret = pci_read_vpd(adapter->pdev, addr, VPD_LEN, vpd);
if (ret < 0)
@@ -667,6 +675,7 @@
i = pci_vpd_info_field_size(vpd + sn - PCI_VPD_INFO_FLD_HDR_SIZE);
memcpy(p->sn, vpd + sn, min(i, SERNUM_LEN));
strim(p->sn);
+ i = pci_vpd_info_field_size(vpd + pn - PCI_VPD_INFO_FLD_HDR_SIZE);
memcpy(p->pn, vpd + pn, min(i, PN_LEN));
strim(p->pn);