drm/radeon/kms: set HPD polarity in hpd_init()
Polarity needs to be set accordingly to connector status (connected
or disconnected). Set it up in hpd_init() so first hotplug works
reliably no matter what is the initial set of connector. hpd_init()
also covers resume so HPD will work correctly after resume as well.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: Jerome Glisse <j.glisse@gmail.com>
Cc: stable@kernel.org
Signed-off-by: Dave Airlie <airlied@redhat.com>
diff --git a/drivers/gpu/drm/radeon/r600.c b/drivers/gpu/drm/radeon/r600.c
index 75b8e00..ff3ae48 100644
--- a/drivers/gpu/drm/radeon/r600.c
+++ b/drivers/gpu/drm/radeon/r600.c
@@ -762,13 +762,14 @@
struct drm_device *dev = rdev->ddev;
struct drm_connector *connector;
- if (ASIC_IS_DCE3(rdev)) {
- u32 tmp = DC_HPDx_CONNECTION_TIMER(0x9c4) | DC_HPDx_RX_INT_TIMER(0xfa);
- if (ASIC_IS_DCE32(rdev))
- tmp |= DC_HPDx_EN;
+ list_for_each_entry(connector, &dev->mode_config.connector_list, head) {
+ struct radeon_connector *radeon_connector = to_radeon_connector(connector);
- list_for_each_entry(connector, &dev->mode_config.connector_list, head) {
- struct radeon_connector *radeon_connector = to_radeon_connector(connector);
+ if (ASIC_IS_DCE3(rdev)) {
+ u32 tmp = DC_HPDx_CONNECTION_TIMER(0x9c4) | DC_HPDx_RX_INT_TIMER(0xfa);
+ if (ASIC_IS_DCE32(rdev))
+ tmp |= DC_HPDx_EN;
+
switch (radeon_connector->hpd.hpd) {
case RADEON_HPD_1:
WREG32(DC_HPD1_CONTROL, tmp);
@@ -798,10 +799,7 @@
default:
break;
}
- }
- } else {
- list_for_each_entry(connector, &dev->mode_config.connector_list, head) {
- struct radeon_connector *radeon_connector = to_radeon_connector(connector);
+ } else {
switch (radeon_connector->hpd.hpd) {
case RADEON_HPD_1:
WREG32(DC_HOT_PLUG_DETECT1_CONTROL, DC_HOT_PLUG_DETECTx_EN);
@@ -819,6 +817,7 @@
break;
}
}
+ radeon_hpd_set_polarity(rdev, radeon_connector->hpd.hpd);
}
if (rdev->irq.installed)
r600_irq_set(rdev);