ath9k: Use the Beacon TX rate from mac80211
Instead of hardcoding the lowest rate for Beacon frames, use the rate
index specified in the mac80211 TX info in AP mode.
Signed-off-by: Jouni Malinen <jouni.malinen@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/beacon.c b/drivers/net/wireless/ath/ath9k/beacon.c
index d088ebf..42171d0 100644
--- a/drivers/net/wireless/ath/ath9k/beacon.c
+++ b/drivers/net/wireless/ath/ath9k/beacon.c
@@ -62,7 +62,7 @@
* Beacons are always sent out at the lowest rate, and are not retried.
*/
static void ath_beacon_setup(struct ath_softc *sc, struct ath_vif *avp,
- struct ath_buf *bf)
+ struct ath_buf *bf, int rateidx)
{
struct sk_buff *skb = bf->bf_mpdu;
struct ath_hw *ah = sc->sc_ah;
@@ -96,9 +96,9 @@
ds->ds_data = bf->bf_buf_addr;
sband = &sc->sbands[common->hw->conf.channel->band];
- rate = sband->bitrates[0].hw_value;
+ rate = sband->bitrates[rateidx].hw_value;
if (sc->sc_flags & SC_OP_PREAMBLE_SHORT)
- rate |= sband->bitrates[0].hw_value_short;
+ rate |= sband->bitrates[rateidx].hw_value_short;
ath9k_hw_set11n_txdesc(ah, ds, skb->len + FCS_LEN,
ATH9K_PKT_TYPE_BEACON,
@@ -206,7 +206,7 @@
}
}
- ath_beacon_setup(sc, avp, bf);
+ ath_beacon_setup(sc, avp, bf, info->control.rates[0].idx);
while (skb) {
ath_tx_cabq(hw, skb);
@@ -237,7 +237,7 @@
bf = avp->av_bcbuf;
skb = bf->bf_mpdu;
- ath_beacon_setup(sc, avp, bf);
+ ath_beacon_setup(sc, avp, bf, 0);
/* NB: caller is known to have already stopped tx dma */
ath9k_hw_puttxbuf(ah, sc->beacon.beaconq, bf->bf_daddr);