net/mlx4_core: Do not reset module-parameter num_vfs when fail to enable sriov
Consider the following scenario: 2 HCAs, where only one of which can run SRIOV.
If we reset the module parameter, all the VFs of the SRIOV HCA will be
claimed by the PPF host (-- the code relies on num_vfs being non-zero
to avoid this claiming, and num_vfs was reset when pci_enable_sriov failed
for the non-SRIOV HCA).
The solution is not to touch the num_vfs parameter.
Also, eliminate the unneeded check of num_vfs when disabling sriov
(the dev flag bit is sufficient).
Signed-off-by: Jack Morgenstein <jackm@dev.mellanox.co.il>
Signed-off-by: Or Gerlitz <ogerlitz@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/mellanox/mlx4/main.c b/drivers/net/ethernet/mellanox/mlx4/main.c
index 8bb05b4..8eed1f2 100644
--- a/drivers/net/ethernet/mellanox/mlx4/main.c
+++ b/drivers/net/ethernet/mellanox/mlx4/main.c
@@ -1865,7 +1865,6 @@
mlx4_err(dev, "Failed to enable sriov,"
"continuing without sriov enabled"
" (err = %d).\n", err);
- num_vfs = 0;
err = 0;
} else {
mlx4_warn(dev, "Running in master mode\n");
@@ -2022,7 +2021,7 @@
mlx4_cmd_cleanup(dev);
err_sriov:
- if (num_vfs && (dev->flags & MLX4_FLAG_SRIOV))
+ if (dev->flags & MLX4_FLAG_SRIOV)
pci_disable_sriov(pdev);
err_rel_own:
@@ -2099,7 +2098,7 @@
if (dev->flags & MLX4_FLAG_MSI_X)
pci_disable_msix(pdev);
- if (num_vfs && (dev->flags & MLX4_FLAG_SRIOV)) {
+ if (dev->flags & MLX4_FLAG_SRIOV) {
mlx4_warn(dev, "Disabling sriov\n");
pci_disable_sriov(pdev);
}