EEPROM: max6875: Header file cleanup
Change max6875.c header file to format as in conventions
Signed-off-by: Abraham Arce <x0066660@ti.com>
Acked-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/drivers/misc/eeprom/max6875.c b/drivers/misc/eeprom/max6875.c
index 5a6b2bc..fe29092 100644
--- a/drivers/misc/eeprom/max6875.c
+++ b/drivers/misc/eeprom/max6875.c
@@ -1,30 +1,30 @@
/*
- max6875.c - driver for MAX6874/MAX6875
-
- Copyright (C) 2005 Ben Gardner <bgardner@wabtec.com>
-
- Based on eeprom.c
-
- The MAX6875 has a bank of registers and two banks of EEPROM.
- Address ranges are defined as follows:
- * 0x0000 - 0x0046 = configuration registers
- * 0x8000 - 0x8046 = configuration EEPROM
- * 0x8100 - 0x82FF = user EEPROM
-
- This driver makes the user EEPROM available for read.
-
- The registers & config EEPROM should be accessed via i2c-dev.
-
- The MAX6875 ignores the lowest address bit, so each chip responds to
- two addresses - 0x50/0x51 and 0x52/0x53.
-
- Note that the MAX6875 uses i2c_smbus_write_byte_data() to set the read
- address, so this driver is destructive if loaded for the wrong EEPROM chip.
-
- This program is free software; you can redistribute it and/or modify
- it under the terms of the GNU General Public License as published by
- the Free Software Foundation; version 2 of the License.
-*/
+ * max6875.c - driver for MAX6874/MAX6875
+ *
+ * Copyright (C) 2005 Ben Gardner <bgardner@wabtec.com>
+ *
+ * Based on eeprom.c
+ *
+ * The MAX6875 has a bank of registers and two banks of EEPROM.
+ * Address ranges are defined as follows:
+ * * 0x0000 - 0x0046 = configuration registers
+ * * 0x8000 - 0x8046 = configuration EEPROM
+ * * 0x8100 - 0x82FF = user EEPROM
+ *
+ * This driver makes the user EEPROM available for read.
+ *
+ * The registers & config EEPROM should be accessed via i2c-dev.
+ *
+ * The MAX6875 ignores the lowest address bit, so each chip responds to
+ * two addresses - 0x50/0x51 and 0x52/0x53.
+ *
+ * Note that the MAX6875 uses i2c_smbus_write_byte_data() to set the read
+ * address, so this driver is destructive if loaded for the wrong EEPROM chip.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; version 2 of the License.
+ */
#include <linux/kernel.h>
#include <linux/init.h>