ath9k: improve BT FTP/PAN performance
When BT FTP/PAN transmits while WLAN is idle, the one of 9462 chain
often picks up BT's tx signal and starts receiving. If the current
weight is set to be higher than BT tx, BT tx will be aborted and this
also degrades BT performance. Hence lower WLAN rx priority in this
case only when there are no WLAN traffic.
Signed-off-by: Rajkumar Manoharan <rmanohar@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/gpio.c b/drivers/net/wireless/ath/ath9k/gpio.c
index 9397a6d..af6d273 100644
--- a/drivers/net/wireless/ath/ath9k/gpio.c
+++ b/drivers/net/wireless/ath/ath9k/gpio.c
@@ -191,6 +191,7 @@
struct ath_softc *sc = (struct ath_softc *) data;
struct ath_hw *ah = sc->sc_ah;
struct ath_btcoex *btcoex = &sc->btcoex;
+ struct ath_mci_profile *mci = &btcoex->mci;
u32 timer_period;
bool is_btscan;
@@ -199,6 +200,18 @@
ath_detect_bt_priority(sc);
is_btscan = test_bit(BT_OP_SCAN, &btcoex->op_flags);
+ btcoex->bt_wait_time += btcoex->btcoex_period;
+ if (btcoex->bt_wait_time > ATH_BTCOEX_RX_WAIT_TIME) {
+ if (ar9003_mci_state(ah, MCI_STATE_NEED_FTP_STOMP, NULL) &&
+ (mci->num_pan || mci->num_other_acl))
+ ah->btcoex_hw.mci.stomp_ftp =
+ (sc->rx.num_pkts < ATH_BTCOEX_STOMP_FTP_THRESH);
+ else
+ ah->btcoex_hw.mci.stomp_ftp = false;
+ btcoex->bt_wait_time = 0;
+ sc->rx.num_pkts = 0;
+ }
+
spin_lock_bh(&btcoex->btcoex_lock);
ath9k_hw_btcoex_bt_stomp(ah, is_btscan ? ATH_BTCOEX_STOMP_ALL :