ath5k: fix typos, bad comment formatting and GHz in place of MHz
Signed-off-by: Pavel Roskin <proski@gnu.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath5k/reset.c b/drivers/net/wireless/ath/ath5k/reset.c
index 19aefdb..57f2e56 100644
--- a/drivers/net/wireless/ath/ath5k/reset.c
+++ b/drivers/net/wireless/ath/ath5k/reset.c
@@ -213,7 +213,7 @@
usec_reg = (usec | sclock | txlat | rxlat);
ath5k_hw_reg_write(ah, usec_reg, AR5K_USEC);
- /* On 5112 set tx frane to tx data start delay */
+ /* On 5112 set tx frame to tx data start delay */
if (ah->ah_radio == AR5K_RF5112) {
AR5K_REG_WRITE_BITS(ah, AR5K_PHY_RF_CTL2,
AR5K_PHY_RF_CTL2_TXF2TXD_START,
@@ -539,7 +539,7 @@
*
* Note: putting PCI core on warm reset on PCI-E cards
* results card to hang and always return 0xffff... so
- * we ingore that flag for PCI-E cards. On PCI cards
+ * we ignore that flag for PCI-E cards. On PCI cards
* this flag gets cleared after 64 PCI clocks.
*/
bus_flags = (pdev && pci_is_pcie(pdev)) ? 0 : AR5K_RESET_CTL_PCI;
@@ -596,7 +596,7 @@
*
* Note: putting PCI core on warm reset on PCI-E cards
* results card to hang and always return 0xffff... so
- * we ingore that flag for PCI-E cards. On PCI cards
+ * we ignore that flag for PCI-E cards. On PCI cards
* this flag gets cleared after 64 PCI clocks.
*/
bus_flags = (pdev && pci_is_pcie(pdev)) ? 0 : AR5K_RESET_CTL_PCI;
@@ -627,7 +627,7 @@
return ret;
}
- /* ...reset configuration regiter on Wisoc ...
+ /* ...reset configuration register on Wisoc ...
* ...clear reset control register and pull device out of
* warm reset on others */
if (ath5k_get_bus_type(ah) == ATH_AHB)
@@ -704,7 +704,7 @@
/*XXX: Can bwmode be used with dynamic mode ?
* (I don't think it supports 44MHz) */
- /* On 2425 initvals TURBO_SHORT is not pressent */
+ /* On 2425 initvals TURBO_SHORT is not present */
if (ah->ah_bwmode == AR5K_BWMODE_40MHZ) {
turbo = AR5K_PHY_TURBO_MODE |
(ah->ah_radio == AR5K_RF2425) ? 0 :