[NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.
The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.
Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/lapb/Kconfig b/net/lapb/Kconfig
new file mode 100644
index 0000000..f0b5efb
--- /dev/null
+++ b/net/lapb/Kconfig
@@ -0,0 +1,22 @@
+#
+# LAPB Data Link Drive
+#
+
+config LAPB
+ tristate "LAPB Data Link Driver (EXPERIMENTAL)"
+ depends on EXPERIMENTAL
+ ---help---
+ Link Access Procedure, Balanced (LAPB) is the data link layer (i.e.
+ the lower) part of the X.25 protocol. It offers a reliable
+ connection service to exchange data frames with one other host, and
+ it is used to transport higher level protocols (mostly X.25 Packet
+ Layer, the higher part of X.25, but others are possible as well).
+ Usually, LAPB is used with specialized X.21 network cards, but Linux
+ currently supports LAPB only over Ethernet connections. If you want
+ to use LAPB connections over Ethernet, say Y here and to "LAPB over
+ Ethernet driver" below. Read
+ <file:Documentation/networking/lapb-module.txt> for technical
+ details.
+
+ To compile this driver as a module, choose M here: the
+ module will be called lapb. If unsure, say N.