[PATCH] md: Don't clear bits in bitmap when writing to one device fails during recovery
Currently a device failure during recovery leaves bits set in the bitmap.
This normally isn't a problem as the offending device will be rejected because
of errors. However if device re-adding is being used with non-persistent
bitmaps, this can be a problem.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/md/raid1.c b/drivers/md/raid1.c
index 3cb0872..9b374c9 100644
--- a/drivers/md/raid1.c
+++ b/drivers/md/raid1.c
@@ -1135,8 +1135,19 @@
mirror = i;
break;
}
- if (!uptodate)
+ if (!uptodate) {
+ int sync_blocks = 0;
+ sector_t s = r1_bio->sector;
+ long sectors_to_go = r1_bio->sectors;
+ /* make sure these bits doesn't get cleared. */
+ do {
+ bitmap_end_sync(mddev->bitmap, r1_bio->sector,
+ &sync_blocks, 1);
+ s += sync_blocks;
+ sectors_to_go -= sync_blocks;
+ } while (sectors_to_go > 0);
md_error(mddev, conf->mirrors[mirror].rdev);
+ }
update_head_pos(mirror, r1_bio);