ath10k: fix WMI scan command length
Fix WMI scan command length we setup when scan request.
This fix issue with 636 firmware when scan always failed
with message:
ath10k_pci 0000:02:00.0: wmi start scan
ath10k_pci 0000:02:00.0: wmi stop scan reqid 1 req_type 0 vdev/scan_id 0
ath10k_pci 0000:02:00.0: failed to stop wmi scan: -11
ath10k_pci 0000:02:00.0: failed to stop scan: -11
ath10k_pci 0000:02:00.0: failed to start hw scan: -110
Signed-off-by: Janusz Dziedzic <janusz.dziedzic@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c
index c145b98..7ca9dcb 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.c
+++ b/drivers/net/wireless/ath/ath10k/wmi.c
@@ -3506,10 +3506,10 @@
return ret;
if (test_bit(ATH10K_FW_FEATURE_WMI_10X, ar->fw_features))
- len = sizeof(struct wmi_start_scan_cmd) +
+ len = sizeof(struct wmi_10x_start_scan_cmd) +
ath10k_wmi_start_scan_tlvs_len(arg);
else
- len = sizeof(struct wmi_10x_start_scan_cmd) +
+ len = sizeof(struct wmi_start_scan_cmd) +
ath10k_wmi_start_scan_tlvs_len(arg);
skb = ath10k_wmi_alloc_skb(ar, len);