Blackfin: bf537: rename ad2s120x ->ad2s1200
In v3.2 the Analog Devices ad2s1200/ad2s1205 driver was renamed from
ad2s120x to ad2s1200. But it apparently forgot to rename the references
to this driver in the BF537-STAMP code. Rename these now, and use the
IS_ENABLED() macro, while we're at it.
Signed-off-by: Paul Bolle <pebolle@tiscali.nl>
diff --git a/arch/blackfin/mach-bf537/boards/stamp.c b/arch/blackfin/mach-bf537/boards/stamp.c
index 50c2b0a..60ce598 100644
--- a/arch/blackfin/mach-bf537/boards/stamp.c
+++ b/arch/blackfin/mach-bf537/boards/stamp.c
@@ -655,13 +655,13 @@
};
#endif
-#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
-static unsigned short ad2s120x_platform_data[] = {
+#if IS_ENABLED(CONFIG_AD2S1200)
+static unsigned short ad2s1200_platform_data[] = {
/* used as SAMPLE and RDVEL */
GPIO_PF5, GPIO_PF6, 0
};
-static struct bfin5xx_spi_chip ad2s120x_spi_chip_info = {
+static struct bfin5xx_spi_chip ad2s1200_spi_chip_info = {
.enable_dma = 0,
};
#endif
@@ -1019,13 +1019,13 @@
},
#endif
-#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
+#if IS_ENABLED(CONFIG_AD2S1200)
{
- .modalias = "ad2s120x",
+ .modalias = "ad2s1200",
.bus_num = 0,
.chip_select = 4, /* CS, change it for your board */
- .platform_data = ad2s120x_platform_data,
- .controller_data = &ad2s120x_spi_chip_info,
+ .platform_data = ad2s1200_platform_data,
+ .controller_data = &ad2s1200_spi_chip_info,
},
#endif