ixgbe: implement SFF diagnostic monitoring via ethtool
This patch adds support for reading data from SFP+ modules over i2c.
Signed-off-by: Aurélien Guillaume <footplus@gmail.com>
Signed-off-by: Emil Tantilov <emil.s.tantilov@intel.com>
Tested-by: Phil Schmitt <phillip.j.schmitt@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c
index 7349a8b..e6cebdc 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c
@@ -39,6 +39,7 @@
#include <linux/uaccess.h>
#include "ixgbe.h"
+#include "ixgbe_phy.h"
#define IXGBE_ALL_RAR_ENTRIES 16
@@ -2839,6 +2840,117 @@
return ixgbe_setup_tc(dev, netdev_get_num_tc(dev));
}
+static int ixgbe_get_module_info(struct net_device *dev,
+ struct ethtool_modinfo *modinfo)
+{
+ struct ixgbe_adapter *adapter = netdev_priv(dev);
+ struct ixgbe_hw *hw = &adapter->hw;
+ u32 status;
+ u8 sff8472_rev, addr_mode;
+ int ret_val = 0;
+ bool page_swap = false;
+
+ /* avoid concurent i2c reads */
+ while (test_bit(__IXGBE_IN_SFP_INIT, &adapter->state))
+ msleep(100);
+
+ /* used by the service task */
+ set_bit(__IXGBE_READ_I2C, &adapter->state);
+
+ /* Check whether we support SFF-8472 or not */
+ status = hw->phy.ops.read_i2c_eeprom(hw,
+ IXGBE_SFF_SFF_8472_COMP,
+ &sff8472_rev);
+ if (status != 0) {
+ ret_val = -EIO;
+ goto err_out;
+ }
+
+ /* addressing mode is not supported */
+ status = hw->phy.ops.read_i2c_eeprom(hw,
+ IXGBE_SFF_SFF_8472_SWAP,
+ &addr_mode);
+ if (status != 0) {
+ ret_val = -EIO;
+ goto err_out;
+ }
+
+ if (addr_mode & IXGBE_SFF_ADDRESSING_MODE) {
+ e_err(drv, "Address change required to access page 0xA2, but not supported. Please report the module type to the driver maintainers.\n");
+ page_swap = true;
+ }
+
+ if (sff8472_rev == IXGBE_SFF_SFF_8472_UNSUP || page_swap) {
+ /* We have a SFP, but it does not support SFF-8472 */
+ modinfo->type = ETH_MODULE_SFF_8079;
+ modinfo->eeprom_len = ETH_MODULE_SFF_8079_LEN;
+ } else {
+ /* We have a SFP which supports a revision of SFF-8472. */
+ modinfo->type = ETH_MODULE_SFF_8472;
+ modinfo->eeprom_len = ETH_MODULE_SFF_8472_LEN;
+ }
+
+err_out:
+ clear_bit(__IXGBE_READ_I2C, &adapter->state);
+ return ret_val;
+}
+
+static int ixgbe_get_module_eeprom(struct net_device *dev,
+ struct ethtool_eeprom *ee,
+ u8 *data)
+{
+ struct ixgbe_adapter *adapter = netdev_priv(dev);
+ struct ixgbe_hw *hw = &adapter->hw;
+ u32 status = IXGBE_ERR_PHY_ADDR_INVALID;
+ u8 databyte = 0xFF;
+ int i = 0;
+ int ret_val = 0;
+
+ /* ixgbe_get_module_info is called before this function in all
+ * cases, so we do not need any checks we already do above,
+ * and can trust ee->len to be a known value.
+ */
+
+ while (test_bit(__IXGBE_IN_SFP_INIT, &adapter->state))
+ msleep(100);
+ set_bit(__IXGBE_READ_I2C, &adapter->state);
+
+ /* Read the first block, SFF-8079 */
+ for (i = 0; i < ETH_MODULE_SFF_8079_LEN; i++) {
+ status = hw->phy.ops.read_i2c_eeprom(hw, i, &databyte);
+ if (status != 0) {
+ /* Error occured while reading module */
+ ret_val = -EIO;
+ goto err_out;
+ }
+ data[i] = databyte;
+ }
+
+ /* If the second block is requested, check if SFF-8472 is supported. */
+ if (ee->len == ETH_MODULE_SFF_8472_LEN) {
+ if (data[IXGBE_SFF_SFF_8472_COMP] == IXGBE_SFF_SFF_8472_UNSUP)
+ return -EOPNOTSUPP;
+
+ /* Read the second block, SFF-8472 */
+ for (i = ETH_MODULE_SFF_8079_LEN;
+ i < ETH_MODULE_SFF_8472_LEN; i++) {
+ status = hw->phy.ops.read_i2c_sff8472(hw,
+ i - ETH_MODULE_SFF_8079_LEN, &databyte);
+ if (status != 0) {
+ /* Error occured while reading module */
+ ret_val = -EIO;
+ goto err_out;
+ }
+ data[i] = databyte;
+ }
+ }
+
+err_out:
+ clear_bit(__IXGBE_READ_I2C, &adapter->state);
+
+ return ret_val;
+}
+
static const struct ethtool_ops ixgbe_ethtool_ops = {
.get_settings = ixgbe_get_settings,
.set_settings = ixgbe_set_settings,
@@ -2870,6 +2982,8 @@
.get_channels = ixgbe_get_channels,
.set_channels = ixgbe_set_channels,
.get_ts_info = ixgbe_get_ts_info,
+ .get_module_info = ixgbe_get_module_info,
+ .get_module_eeprom = ixgbe_get_module_eeprom,
};
void ixgbe_set_ethtool_ops(struct net_device *netdev)