[PATCH] hot-add-mem x86_64: Enable SPARSEMEM in srat.c
Enable x86_64 srat.c to share code between both reserve and sparsemem based
add memory paths. Both paths need the hot-add area node locality infomration
(nodes_add). This code refactors the code path to allow this.
Signed-off-by: Keith Mannthey <kmannth@us.ibm.com>
Cc: KAMEZAWA Hiroyuki <kamezawa.hiroyu@jp.fujitsu.com>
Cc: Andi Kleen <ak@muc.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/arch/x86_64/mm/srat.c b/arch/x86_64/mm/srat.c
index f8c04d6..19396a2 100644
--- a/arch/x86_64/mm/srat.c
+++ b/arch/x86_64/mm/srat.c
@@ -23,12 +23,6 @@
int acpi_numa __initdata;
-#if (defined(CONFIG_ACPI_HOTPLUG_MEMORY) || \
- defined(CONFIG_ACPI_HOTPLUG_MEMORY_MODULE)) \
- && !defined(CONFIG_MEMORY_HOTPLUG)
-#define RESERVE_HOTADD 1
-#endif
-
static struct acpi_table_slit *acpi_slit;
static nodemask_t nodes_parsed __initdata;
@@ -36,9 +30,6 @@
static struct bootnode nodes_add[MAX_NUMNODES] __initdata;
static int found_add_area __initdata;
int hotadd_percent __initdata = 0;
-#ifndef RESERVE_HOTADD
-#define hotadd_percent 0 /* Ignore all settings */
-#endif
/* Too small nodes confuse the VM badly. Usually they result
from BIOS bugs. */
@@ -160,7 +151,7 @@
pxm, pa->apic_id, node);
}
-#ifdef RESERVE_HOTADD
+#ifdef CONFIG_MEMORY_HOTPLUG_RESERVE
/*
* Protect against too large hotadd areas that would fill up memory.
*/
@@ -203,15 +194,37 @@
return 1;
}
+static int update_end_of_memory(unsigned long end)
+{
+ found_add_area = 1;
+ if ((end >> PAGE_SHIFT) > end_pfn)
+ end_pfn = end >> PAGE_SHIFT;
+ return 1;
+}
+
+static inline int save_add_info(void)
+{
+ return hotadd_percent > 0;
+}
+#else
+int update_end_of_memory(unsigned long end) {return 0;}
+static int hotadd_enough_memory(struct bootnode *nd) {return 1;}
+#ifdef CONFIG_MEMORY_HOTPLUG_SPARSE
+static inline int save_add_info(void) {return 1;}
+#else
+static inline int save_add_info(void) {return 0;}
+#endif
+#endif
/*
- * It is fine to add this area to the nodes data it will be used later
+ * Update nodes_add and decide if to include add are in the zone.
+ * Both SPARSE and RESERVE need nodes_add infomation.
* This code supports one contigious hot add area per node.
*/
static int reserve_hotadd(int node, unsigned long start, unsigned long end)
{
unsigned long s_pfn = start >> PAGE_SHIFT;
unsigned long e_pfn = end >> PAGE_SHIFT;
- int changed = 0;
+ int ret = 0, changed = 0;
struct bootnode *nd = &nodes_add[node];
/* I had some trouble with strange memory hotadd regions breaking
@@ -240,7 +253,6 @@
/* Looks good */
- found_add_area = 1;
if (nd->start == nd->end) {
nd->start = start;
nd->end = end;
@@ -258,14 +270,12 @@
printk(KERN_ERR "SRAT: Hotplug zone not continuous. Partly ignored\n");
}
- if ((nd->end >> PAGE_SHIFT) > end_pfn)
- end_pfn = nd->end >> PAGE_SHIFT;
+ ret = update_end_of_memory(nd->end);
if (changed)
printk(KERN_INFO "SRAT: hot plug zone found %Lx - %Lx\n", nd->start, nd->end);
- return 0;
+ return ret;
}
-#endif
/* Callback for parsing of the Proximity Domain <-> Memory Area mappings */
void __init
@@ -284,7 +294,7 @@
}
if (ma->flags.enabled == 0)
return;
- if (ma->flags.hot_pluggable && hotadd_percent == 0)
+ if (ma->flags.hot_pluggable && !save_add_info())
return;
start = ma->base_addr_lo | ((u64)ma->base_addr_hi << 32);
end = start + (ma->length_lo | ((u64)ma->length_hi << 32));
@@ -327,15 +337,13 @@
push_node_boundaries(node, nd->start >> PAGE_SHIFT,
nd->end >> PAGE_SHIFT);
-#ifdef RESERVE_HOTADD
- if (ma->flags.hot_pluggable && reserve_hotadd(node, start, end) < 0) {
+ if (ma->flags.hot_pluggable && !reserve_hotadd(node, start, end) < 0) {
/* Ignore hotadd region. Undo damage */
printk(KERN_NOTICE "SRAT: Hotplug region ignored\n");
*nd = oldnode;
if ((nd->start | nd->end) == 0)
node_clear(node, nodes_parsed);
}
-#endif
}
/* Sanity check to catch more bad SRATs (they are amazingly common).
@@ -351,7 +359,6 @@
unsigned long e = nodes[i].end >> PAGE_SHIFT;
pxmram += e - s;
pxmram -= absent_pages_in_range(s, e);
- pxmram -= nodes_add[i].end - nodes_add[i].start;
if ((long)pxmram < 0)
pxmram = 0;
}