be2net: stop checking the UE registers after an EEH error
Signed-off-by: Sathya Perla <sathya.perla@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index 83d971d..99da07f 100644
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c
@@ -1978,6 +1978,9 @@
u32 sliport_status = 0, sliport_err1 = 0, sliport_err2 = 0;
u32 i;
+ if (adapter->eeh_err || adapter->ue_detected)
+ return;
+
if (lancer_chip(adapter)) {
sliport_status = ioread32(adapter->db + SLIPORT_STATUS_OFFSET);
if (sliport_status & SLIPORT_STATUS_ERR_MASK) {
@@ -2039,8 +2042,7 @@
struct be_rx_obj *rxo;
int i;
- if (!adapter->ue_detected)
- be_detect_dump_ue(adapter);
+ be_detect_dump_ue(adapter);
/* when interrupts are not yet enabled, just reap any pending
* mcc completions */