mfd: rtsx: Read vendor setting from config space
Normally OEMs will set vendor setting to the config space of Realtek
card reader in BIOS stage. This patch reads the setting at the first,
and configure the internal registers according to it, to improve card
reader's compatibility condition.
Signed-off-by: Wei WANG <wei_wang@realsil.com.cn>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/mfd/rtsx_pcr.c b/drivers/mfd/rtsx_pcr.c
index dd186c4..e06d6b0 100644
--- a/drivers/mfd/rtsx_pcr.c
+++ b/drivers/mfd/rtsx_pcr.c
@@ -73,6 +73,9 @@
pcr->state = PDEV_STAT_RUN;
if (pcr->ops->enable_auto_blink)
pcr->ops->enable_auto_blink(pcr);
+
+ if (pcr->aspm_en)
+ rtsx_pci_write_config_byte(pcr, LCTLR, 0);
}
mod_delayed_work(system_wq, &pcr->idle_work, msecs_to_jiffies(200));
@@ -717,7 +720,7 @@
[RTSX_MS_CARD] = MS_EXIST
};
- if (!pcr->ms_pmos) {
+ if (!(pcr->flags & PCR_MS_PMOS)) {
/* When using single PMOS, accessing card is not permitted
* if the existing card is not the designated one.
*/
@@ -918,6 +921,9 @@
if (pcr->ops->turn_off_led)
pcr->ops->turn_off_led(pcr);
+ if (pcr->aspm_en)
+ rtsx_pci_write_config_byte(pcr, LCTLR, pcr->aspm_en);
+
mutex_unlock(&pcr->pcr_mutex);
}
@@ -956,8 +962,8 @@
/* Reset delink mode */
rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, CHANGE_LINK_STATE, 0x0A, 0);
/* Card driving select */
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_DRIVE_SEL,
- 0x07, DRIVER_TYPE_D);
+ rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, CARD_DRIVE_SEL,
+ 0xFF, pcr->card_drive_sel);
/* Enable SSC Clock */
rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SSC_CTL1,
0xFF, SSC_8X_EN | SSC_SEL_4M);
@@ -989,6 +995,8 @@
if (err < 0)
return err;
+ rtsx_pci_write_config_byte(pcr, LCTLR, 0);
+
/* Enable clk_request_n to enable clock power management */
rtsx_pci_write_config_byte(pcr, 0x81, 1);
/* Enter L1 when host tx idle */
@@ -1053,6 +1061,18 @@
if (!pcr->slots)
return -ENOMEM;
+ if (pcr->ops->fetch_vendor_settings)
+ pcr->ops->fetch_vendor_settings(pcr);
+
+ dev_dbg(&(pcr->pci->dev), "pcr->aspm_en = 0x%x\n", pcr->aspm_en);
+ dev_dbg(&(pcr->pci->dev), "pcr->sd30_drive_sel_1v8 = 0x%x\n",
+ pcr->sd30_drive_sel_1v8);
+ dev_dbg(&(pcr->pci->dev), "pcr->sd30_drive_sel_3v3 = 0x%x\n",
+ pcr->sd30_drive_sel_3v3);
+ dev_dbg(&(pcr->pci->dev), "pcr->card_drive_sel = 0x%x\n",
+ pcr->card_drive_sel);
+ dev_dbg(&(pcr->pci->dev), "pcr->flags = 0x%x\n", pcr->flags);
+
pcr->state = PDEV_STAT_IDLE;
err = rtsx_pci_init_hw(pcr);
if (err < 0) {