[MIPS] TXx9: Unify serial_txx9 setup
* Unify calling of early_serial_txx9_setup.
* Use dedicated serial clock on RBTX4938.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/txx9/generic/setup_tx4938.c b/arch/mips/txx9/generic/setup_tx4938.c
index 1ceace4..f3040b9 100644
--- a/arch/mips/txx9/generic/setup_tx4938.c
+++ b/arch/mips/txx9/generic/setup_tx4938.c
@@ -13,7 +13,6 @@
#include <linux/init.h>
#include <linux/ioport.h>
#include <linux/delay.h>
-#include <linux/serial_core.h>
#include <linux/param.h>
#include <asm/txx9irq.h>
#include <asm/txx9tmr.h>
@@ -238,11 +237,9 @@
TXX9_IMCLK);
}
-void __init tx4938_setup_serial(void)
+void __init tx4938_sio_init(unsigned int sclk, unsigned int cts_mask)
{
-#ifdef CONFIG_SERIAL_TXX9
int i;
- struct uart_port req;
unsigned int ch_mask = 0;
if (__raw_readq(&tx4938_ccfgptr->pcfg) & TX4938_PCFG_ETH0_SEL)
@@ -250,17 +247,10 @@
for (i = 0; i < 2; i++) {
if ((1 << i) & ch_mask)
continue;
- memset(&req, 0, sizeof(req));
- req.line = i;
- req.iotype = UPIO_MEM;
- req.membase = (unsigned char __iomem *)TX4938_SIO_REG(i);
- req.mapbase = TX4938_SIO_REG(i) & 0xfffffffffULL;
- req.irq = TXX9_IRQ_BASE + TX4938_IR_SIO(i);
- req.flags |= UPF_BUGGY_UART /*HAVE_CTS_LINE*/;
- req.uartclk = TXX9_IMCLK;
- early_serial_txx9_setup(&req);
+ txx9_sio_init(TX4938_SIO_REG(i) & 0xfffffffffULL,
+ TXX9_IRQ_BASE + TX4938_IR_SIO(i),
+ i, sclk, (1 << i) & cts_mask);
}
-#endif /* CONFIG_SERIAL_TXX9 */
}
void __init tx4938_spi_init(int busid)