[MIPS] IP22: Get rid of volatile in IP22 core code.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/sgi-ip22/ip22-nvram.c b/arch/mips/sgi-ip22/ip22-nvram.c
index fd29fd4..e19d60d 100644
--- a/arch/mips/sgi-ip22/ip22-nvram.c
+++ b/arch/mips/sgi-ip22/ip22-nvram.c
@@ -52,8 +52,7 @@
* national semiconductor nv ram chip the op code is 3 bits and
* the address is 6/8 bits.
*/
-static inline void eeprom_cmd(volatile unsigned int *ctrl, unsigned cmd,
- unsigned reg)
+static inline void eeprom_cmd(unsigned int *ctrl, unsigned cmd, unsigned reg)
{
unsigned short ser_cmd;
int i;
@@ -61,33 +60,34 @@
ser_cmd = cmd | (reg << (16 - BITS_IN_COMMAND));
for (i = 0; i < BITS_IN_COMMAND; i++) {
if (ser_cmd & (1<<15)) /* if high order bit set */
- *ctrl |= EEPROM_DATO;
+ writel(readl(ctrl) | EEPROM_DATO, ctrl);
else
- *ctrl &= ~EEPROM_DATO;
- *ctrl &= ~EEPROM_ECLK;
- *ctrl |= EEPROM_ECLK;
+ writel(readl(ctrl) & ~EEPROM_DATO, ctrl);
+ writel(readl(ctrl) & ~EEPROM_ECLK, ctrl);
+ writel(readl(ctrl) | EEPROM_ECLK, ctrl);
ser_cmd <<= 1;
}
- *ctrl &= ~EEPROM_DATO; /* see data sheet timing diagram */
+ /* see data sheet timing diagram */
+ writel(readl(ctrl) & ~EEPROM_DATO, ctrl);
}
-unsigned short ip22_eeprom_read(volatile unsigned int *ctrl, int reg)
+unsigned short ip22_eeprom_read(unsigned int *ctrl, int reg)
{
unsigned short res = 0;
int i;
- *ctrl &= ~EEPROM_EPROT;
+ writel(readl(ctrl) & ~EEPROM_EPROT, ctrl);
eeprom_cs_on(ctrl);
eeprom_cmd(ctrl, EEPROM_READ, reg);
/* clock the data ouf of serial mem */
for (i = 0; i < 16; i++) {
- *ctrl &= ~EEPROM_ECLK;
+ writel(readl(ctrl) & ~EEPROM_ECLK, ctrl);
delay();
- *ctrl |= EEPROM_ECLK;
+ writel(readl(ctrl) | EEPROM_ECLK, ctrl);
delay();
res <<= 1;
- if (*ctrl & EEPROM_DATI)
+ if (readl(ctrl) & EEPROM_DATI)
res |= 1;
}