tlan: Don't disable internal PHY on cards that use it in 10 Mbps mode
In tlan_reset_adapter, we disable internal PHY when an external one is used.
On cards which use internal PHY in 10 Mbps mode, we enable it later when
setting 10 Mbps mode but it does not really work (PHY fails to reset).
Leave it enabled instead.
Signed-off-by: Ondrej Zary <linux@rainbow-software.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/ti/tlan.c b/drivers/net/ethernet/ti/tlan.c
index 8278150..50ac9e7 100644
--- a/drivers/net/ethernet/ti/tlan.c
+++ b/drivers/net/ethernet/ti/tlan.c
@@ -2237,7 +2237,9 @@
}
}
- if (priv->phy_num == 0)
+ /* don't power down internal PHY if we're going to use it */
+ if (priv->phy_num == 0 ||
+ (priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10))
data |= TLAN_NET_CFG_PHY_EN;
tlan_dio_write16(dev->base_addr, TLAN_NET_CONFIG, (u16) data);
@@ -2688,7 +2690,6 @@
struct tlan_priv *priv = netdev_priv(dev);
u16 an_adv;
u16 an_lpa;
- u16 data;
u16 mode;
u16 phy;
u16 status;
@@ -2721,9 +2722,6 @@
(priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10) &&
(priv->phy_num != 0)) {
priv->phy_num = 0;
- data = TLAN_NET_CFG_1FRAG | TLAN_NET_CFG_1CHAN
- | TLAN_NET_CFG_PHY_EN;
- tlan_dio_write16(dev->base_addr, TLAN_NET_CONFIG, data);
tlan_set_timer(dev, (400*HZ/1000), TLAN_TIMER_PHY_PDOWN);
return;
}