ath10k: dont configure bssid for ap mode
FW creates self-peer for AP internally.
This prevents ath10k from trying to create
explicit self-peer during hw recovery and thus
prevents a timeout and a warning during teardown:
ath10k: removing stale peer $AP_BSSID from vdev_id 0
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index f21d60f..a210800 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -3025,7 +3025,12 @@
arvif->u.ap.hidden_ssid = info->hidden_ssid;
}
- if (changed & BSS_CHANGED_BSSID) {
+ /*
+ * Firmware manages AP self-peer internally so make sure to not create
+ * it in driver. Otherwise AP self-peer deletion may timeout later.
+ */
+ if (changed & BSS_CHANGED_BSSID &&
+ vif->type != NL80211_IFTYPE_AP) {
if (!is_zero_ether_addr(info->bssid)) {
ath10k_dbg(ATH10K_DBG_MAC,
"mac vdev %d create peer %pM\n",