[IPSEC]: Set skb->data to payload in x->mode->output
This patch changes the calling convention so that on entry from
x->mode->output and before entry into x->type->output skb->data
will point to the payload instead of the IP header.
This is essentially a redistribution of skb_push/skb_pull calls
with the aim of minimising them on the common path of tunnel +
ESP.
It'll also let us use the same calling convention between IPv4
and IPv6 with the next patch.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv4/xfrm4_mode_tunnel.c b/net/ipv4/xfrm4_mode_tunnel.c
index 9963700..bac1a91 100644
--- a/net/ipv4/xfrm4_mode_tunnel.c
+++ b/net/ipv4/xfrm4_mode_tunnel.c
@@ -49,8 +49,7 @@
iph = ip_hdr(skb);
skb->transport_header = skb->network_header;
- skb_push(skb, x->props.header_len);
- skb_reset_network_header(skb);
+ skb_set_network_header(skb, -x->props.header_len);
top_iph = ip_hdr(skb);
top_iph->ihl = 5;