mmc: Support for high speed SD cards
Modern SD cards support a clock speed of 50 MHz. Make sure we test for
this capability and do the song and dance required to activate it.
Activating high speed support actually modifies the TRAN_SPEED field
of the CSD. But as the spec says that the cards must report 50 MHz,
we might as well skip re-reading the CSD.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
diff --git a/include/linux/mmc/protocol.h b/include/linux/mmc/protocol.h
index 45c51fd8..2dce60c 100644
--- a/include/linux/mmc/protocol.h
+++ b/include/linux/mmc/protocol.h
@@ -82,6 +82,7 @@
/* class 8 */
/* This is basically the same command as for MMC with some quirks. */
#define SD_SEND_RELATIVE_ADDR 3 /* bcr R6 */
+#define SD_SWITCH 6 /* adtc [31:0] See below R1 */
/* Application commands */
#define SD_APP_SET_BUS_WIDTH 6 /* ac [1:0] bus width R1 */
@@ -101,6 +102,19 @@
*/
/*
+ * SD_SWITCH argument format:
+ *
+ * [31] Check (0) or switch (1)
+ * [30:24] Reserved (0)
+ * [23:20] Function group 6
+ * [19:16] Function group 5
+ * [15:12] Function group 4
+ * [11:8] Function group 3
+ * [7:4] Function group 2
+ * [3:0] Function group 1
+ */
+
+/*
MMC status in R1
Type
e : error bit
@@ -285,6 +299,14 @@
#define MMC_SWITCH_MODE_WRITE_BYTE 0x03 /* Set target to value */
/*
+ * SCR field definitions
+ */
+
+#define SCR_SPEC_VER_0 0 /* Implements system specification 1.0 - 1.01 */
+#define SCR_SPEC_VER_1 1 /* Implements system specification 1.10 */
+#define SCR_SPEC_VER_2 2 /* Implements system specification 2.00 */
+
+/*
* SD bus widths
*/
#define SD_BUS_WIDTH_1 0