Input: Allow compile test of GPIO consumers if !GPIOLIB
The GPIO subsystem provides dummy GPIO consumer functions if GPIOLIB is
not enabled. Hence drivers that depend on GPIOLIB, but use GPIO consumer
functionality only, can still be compiled if GPIOLIB is not enabled.
Relax the dependency on GPIOLIB if COMPILE_TEST is enabled, where
appropriate.
Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig
index d4f0a81..dade381 100644
--- a/drivers/input/misc/Kconfig
+++ b/drivers/input/misc/Kconfig
@@ -259,7 +259,7 @@
config INPUT_GP2A
tristate "Sharp GP2AP002A00F I2C Proximity/Opto sensor driver"
depends on I2C
- depends on GPIOLIB
+ depends on GPIOLIB || COMPILE_TEST
help
Say Y here if you have a Sharp GP2AP002A00F proximity/als combo-chip
hooked to an I2C bus.
@@ -269,7 +269,7 @@
config INPUT_GPIO_BEEPER
tristate "Generic GPIO Beeper support"
- depends on GPIOLIB
+ depends on GPIOLIB || COMPILE_TEST
help
Say Y here if you have a beeper connected to a GPIO pin.
@@ -278,7 +278,7 @@
config INPUT_GPIO_TILT_POLLED
tristate "Polled GPIO tilt switch"
- depends on GPIOLIB
+ depends on GPIOLIB || COMPILE_TEST
select INPUT_POLLDEV
help
This driver implements support for tilt switches connected
@@ -569,7 +569,7 @@
config INPUT_GPIO_ROTARY_ENCODER
tristate "Rotary encoders connected to GPIO pins"
- depends on GPIOLIB
+ depends on GPIOLIB || COMPILE_TEST
help
Say Y here to add support for rotary encoders connected to GPIO lines.
Check file:Documentation/input/rotary-encoder.txt for more
@@ -776,7 +776,8 @@
config INPUT_DRV260X_HAPTICS
tristate "TI DRV260X haptics support"
- depends on INPUT && I2C && GPIOLIB
+ depends on INPUT && I2C
+ depends on GPIOLIB || COMPILE_TEST
select INPUT_FF_MEMLESS
select REGMAP_I2C
help