md: remove unnecessary code from do_md_run
Since commit dfc7064500061677720fa26352963c772d3ebe6b,
->hot_remove_disks has not removed non-failed devices from
an array until recovery is no longer possible.
So the code in do_md_run to get around the fact that
md_check_recovery (which calls ->hot_remove_disks) would
remove partially-in-sync devices is no longer needed.
So remove it.
Signed-off-by: NeilBrown <neilb@suse.de>
diff --git a/drivers/md/md.c b/drivers/md/md.c
index fd55f2a..c4bdf06 100644
--- a/drivers/md/md.c
+++ b/drivers/md/md.c
@@ -4421,34 +4421,6 @@
set_capacity(disk, mddev->array_sectors);
- /* If there is a partially-recovered drive we need to
- * start recovery here. If we leave it to md_check_recovery,
- * it will remove the drives and not do the right thing
- */
- if (mddev->degraded && !mddev->sync_thread) {
- int spares = 0;
- list_for_each_entry(rdev, &mddev->disks, same_set)
- if (rdev->raid_disk >= 0 &&
- !test_bit(In_sync, &rdev->flags) &&
- !test_bit(Faulty, &rdev->flags))
- /* complete an interrupted recovery */
- spares++;
- if (spares && mddev->pers->sync_request) {
- mddev->recovery = 0;
- set_bit(MD_RECOVERY_RUNNING, &mddev->recovery);
- set_bit(MD_RECOVERY_RECOVER, &mddev->recovery);
- mddev->sync_thread = md_register_thread(md_do_sync,
- mddev,
- "resync");
- if (!mddev->sync_thread) {
- printk(KERN_ERR "%s: could not start resync"
- " thread...\n",
- mdname(mddev));
- /* leave the spares where they are, it shouldn't hurt */
- mddev->recovery = 0;
- }
- }
- }
md_wakeup_thread(mddev->thread);
md_wakeup_thread(mddev->sync_thread); /* possibly kick off a reshape */