iwlwifi: mvm: assign cab queue to the correct station
Currently when configuring the cab queue the scheduler is configured
without station id - which results in station id 0.
In DQA mode this causes firmware to assert later on when the actual
station 0 is added with an empty tfd_queue_mask.
Fix that by configuring the queue to the broadcast station.
This is a bit trickier since the queue should not be included in the
tfd_queue_mask of the ADD_STA since it is a multicast queue, and the
tfd_queue_mask is only unicast queue. As a result the queue should be
enabled only after the broadcast station is added.
Signed-off-by: Sara Sharon <sara.sharon@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/mac-ctxt.c b/drivers/net/wireless/intel/iwlwifi/mvm/mac-ctxt.c
index 9a91203..4a0874e 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/mac-ctxt.c
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/mac-ctxt.c
@@ -499,23 +499,21 @@
if (ret)
return ret;
+ /* If DQA is supported - queues will be enabled when needed */
+ if (iwl_mvm_is_dqa_supported(mvm))
+ return 0;
+
switch (vif->type) {
case NL80211_IFTYPE_P2P_DEVICE:
- if (!iwl_mvm_is_dqa_supported(mvm))
- iwl_mvm_enable_ac_txq(mvm, IWL_MVM_OFFCHANNEL_QUEUE,
- IWL_MVM_OFFCHANNEL_QUEUE,
- IWL_MVM_TX_FIFO_VO, 0,
- wdg_timeout);
+ iwl_mvm_enable_ac_txq(mvm, IWL_MVM_OFFCHANNEL_QUEUE,
+ IWL_MVM_OFFCHANNEL_QUEUE,
+ IWL_MVM_TX_FIFO_VO, 0, wdg_timeout);
break;
case NL80211_IFTYPE_AP:
iwl_mvm_enable_ac_txq(mvm, vif->cab_queue, vif->cab_queue,
IWL_MVM_TX_FIFO_MCAST, 0, wdg_timeout);
/* fall through */
default:
- /* If DQA is supported - queues will be enabled when needed */
- if (iwl_mvm_is_dqa_supported(mvm))
- break;
-
for (ac = 0; ac < IEEE80211_NUM_ACS; ac++)
iwl_mvm_enable_ac_txq(mvm, vif->hw_queue[ac],
vif->hw_queue[ac],