Merge branch 'master' of master.kernel.org:/pub/scm/linux/kernel/git/davem/net
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
index 23b37dd..93bff08 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
@@ -65,8 +65,9 @@
fp->disable_tpa = ((bp->flags & TPA_ENABLE_FLAG) == 0);
#ifdef BCM_CNIC
- /* We don't want TPA on FCoE, FWD and OOO L2 rings */
- bnx2x_fcoe(bp, disable_tpa) = 1;
+ /* We don't want TPA on an FCoE L2 ring */
+ if (IS_FCOE_FP(fp))
+ fp->disable_tpa = 1;
#endif
}
@@ -1410,10 +1411,9 @@
u16 bnx2x_select_queue(struct net_device *dev, struct sk_buff *skb)
{
struct bnx2x *bp = netdev_priv(dev);
+
#ifdef BCM_CNIC
- if (NO_FCOE(bp))
- return skb_tx_hash(dev, skb);
- else {
+ if (!NO_FCOE(bp)) {
struct ethhdr *hdr = (struct ethhdr *)skb->data;
u16 ether_type = ntohs(hdr->h_proto);
@@ -1430,8 +1430,7 @@
return bnx2x_fcoe_tx(bp, txq_index);
}
#endif
- /* Select a none-FCoE queue: if FCoE is enabled, exclude FCoE L2 ring
- */
+ /* select a non-FCoE queue */
return __skb_tx_hash(dev, skb, BNX2X_NUM_ETH_QUEUES(bp));
}
@@ -1454,6 +1453,28 @@
bp->num_queues += NON_ETH_CONTEXT_USE;
}
+/**
+ * bnx2x_set_real_num_queues - configure netdev->real_num_[tx,rx]_queues
+ *
+ * @bp: Driver handle
+ *
+ * We currently support for at most 16 Tx queues for each CoS thus we will
+ * allocate a multiple of 16 for ETH L2 rings according to the value of the
+ * bp->max_cos.
+ *
+ * If there is an FCoE L2 queue the appropriate Tx queue will have the next
+ * index after all ETH L2 indices.
+ *
+ * If the actual number of Tx queues (for each CoS) is less than 16 then there
+ * will be the holes at the end of each group of 16 ETh L2 indices (0..15,
+ * 16..31,...) with indicies that are not coupled with any real Tx queue.
+ *
+ * The proper configuration of skb->queue_mapping is handled by
+ * bnx2x_select_queue() and __skb_tx_hash().
+ *
+ * bnx2x_setup_tc() takes care of the proper TC mappings so that __skb_tx_hash()
+ * will return a proper Tx index if TC is enabled (netdev->num_tc > 0).
+ */
static inline int bnx2x_set_real_num_queues(struct bnx2x *bp)
{
int rc, tx, rx;
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_dcb.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_dcb.c
index 9525b93..0b9bd55 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_dcb.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_dcb.c
@@ -923,7 +923,7 @@
void bnx2x_dcbx_set_state(struct bnx2x *bp, bool dcb_on, u32 dcbx_enabled)
{
- if (!CHIP_IS_E1x(bp)) {
+ if (!CHIP_IS_E1x(bp) && !CHIP_IS_E3(bp)) {
bp->dcb_state = dcb_on;
bp->dcbx_enabled = dcbx_enabled;
} else {
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
index f4ab90c..7204789 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
@@ -5794,6 +5794,12 @@
DP(BNX2X_MSG_MCP, "starting common init func %d\n", BP_ABS_FUNC(bp));
+ /*
+ * take the UNDI lock to protect undi_unload flow from accessing
+ * registers while we're resetting the chip
+ */
+ bnx2x_acquire_hw_lock(bp, HW_LOCK_RESOURCE_UNDI);
+
bnx2x_reset_common(bp);
REG_WR(bp, GRCBASE_MISC + MISC_REGISTERS_RESET_REG_1_SET, 0xffffffff);
@@ -5804,6 +5810,8 @@
}
REG_WR(bp, GRCBASE_MISC + MISC_REGISTERS_RESET_REG_2_SET, val);
+ bnx2x_release_hw_lock(bp, HW_LOCK_RESOURCE_UNDI);
+
bnx2x_init_block(bp, BLOCK_MISC, PHASE_COMMON);
if (!CHIP_IS_E1x(bp)) {
@@ -10245,10 +10253,17 @@
/* clean indirect addresses */
pci_write_config_dword(bp->pdev, PCICFG_GRC_ADDRESS,
PCICFG_VENDOR_ID_OFFSET);
- REG_WR(bp, PXP2_REG_PGL_ADDR_88_F0 + BP_PORT(bp)*16, 0);
- REG_WR(bp, PXP2_REG_PGL_ADDR_8C_F0 + BP_PORT(bp)*16, 0);
- REG_WR(bp, PXP2_REG_PGL_ADDR_90_F0 + BP_PORT(bp)*16, 0);
- REG_WR(bp, PXP2_REG_PGL_ADDR_94_F0 + BP_PORT(bp)*16, 0);
+ /* Clean the following indirect addresses for all functions since it
+ * is not used by the driver.
+ */
+ REG_WR(bp, PXP2_REG_PGL_ADDR_88_F0, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_8C_F0, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_90_F0, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_94_F0, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_88_F1, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_8C_F1, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_90_F1, 0);
+ REG_WR(bp, PXP2_REG_PGL_ADDR_94_F1, 0);
/*
* Enable internal target-read (in case we are probed after PF FLR).
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_reg.h b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_reg.h
index 27b5ecb..40266c1 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_reg.h
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_reg.h
@@ -3007,11 +3007,27 @@
/* [R 6] Debug only: Number of used entries in the data FIFO */
#define PXP2_REG_HST_DATA_FIFO_STATUS 0x12047c
/* [R 7] Debug only: Number of used entries in the header FIFO */
-#define PXP2_REG_HST_HEADER_FIFO_STATUS 0x120478
-#define PXP2_REG_PGL_ADDR_88_F0 0x120534
-#define PXP2_REG_PGL_ADDR_8C_F0 0x120538
-#define PXP2_REG_PGL_ADDR_90_F0 0x12053c
-#define PXP2_REG_PGL_ADDR_94_F0 0x120540
+#define PXP2_REG_HST_HEADER_FIFO_STATUS 0x120478
+#define PXP2_REG_PGL_ADDR_88_F0 0x120534
+/* [R 32] GRC address for configuration access to PCIE config address 0x88.
+ * any write to this PCIE address will cause a GRC write access to the
+ * address that's in t this register */
+#define PXP2_REG_PGL_ADDR_88_F1 0x120544
+#define PXP2_REG_PGL_ADDR_8C_F0 0x120538
+/* [R 32] GRC address for configuration access to PCIE config address 0x8c.
+ * any write to this PCIE address will cause a GRC write access to the
+ * address that's in t this register */
+#define PXP2_REG_PGL_ADDR_8C_F1 0x120548
+#define PXP2_REG_PGL_ADDR_90_F0 0x12053c
+/* [R 32] GRC address for configuration access to PCIE config address 0x90.
+ * any write to this PCIE address will cause a GRC write access to the
+ * address that's in t this register */
+#define PXP2_REG_PGL_ADDR_90_F1 0x12054c
+#define PXP2_REG_PGL_ADDR_94_F0 0x120540
+/* [R 32] GRC address for configuration access to PCIE config address 0x94.
+ * any write to this PCIE address will cause a GRC write access to the
+ * address that's in t this register */
+#define PXP2_REG_PGL_ADDR_94_F1 0x120550
#define PXP2_REG_PGL_CONTROL0 0x120490
#define PXP2_REG_PGL_CONTROL1 0x120514
#define PXP2_REG_PGL_DEBUG 0x120520