| /* |
| * linux/drivers/pcmcia/pxa2xx_mainstone.c |
| * |
| * Mainstone PCMCIA specific routines. |
| * |
| * Created: May 12, 2004 |
| * Author: Nicolas Pitre |
| * Copyright: MontaVista Software Inc. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| |
| #include <linux/module.h> |
| #include <linux/init.h> |
| #include <linux/kernel.h> |
| #include <linux/errno.h> |
| #include <linux/interrupt.h> |
| #include <linux/device.h> |
| |
| #include <pcmcia/ss.h> |
| |
| #include <asm/hardware.h> |
| #include <asm/irq.h> |
| |
| #include <asm/arch/pxa-regs.h> |
| #include <asm/arch/mainstone.h> |
| |
| #include "soc_common.h" |
| |
| |
| static struct pcmcia_irqs irqs[] = { |
| { 0, MAINSTONE_S0_CD_IRQ, "PCMCIA0 CD" }, |
| { 1, MAINSTONE_S1_CD_IRQ, "PCMCIA1 CD" }, |
| { 0, MAINSTONE_S0_STSCHG_IRQ, "PCMCIA0 STSCHG" }, |
| { 1, MAINSTONE_S1_STSCHG_IRQ, "PCMCIA1 STSCHG" }, |
| }; |
| |
| static int mst_pcmcia_hw_init(struct soc_pcmcia_socket *skt) |
| { |
| /* |
| * Setup default state of GPIO outputs |
| * before we enable them as outputs. |
| */ |
| GPSR(GPIO48_nPOE) = |
| GPIO_bit(GPIO48_nPOE) | |
| GPIO_bit(GPIO49_nPWE) | |
| GPIO_bit(GPIO50_nPIOR) | |
| GPIO_bit(GPIO51_nPIOW) | |
| GPIO_bit(GPIO85_nPCE_1) | |
| GPIO_bit(GPIO54_nPCE_2); |
| |
| pxa_gpio_mode(GPIO48_nPOE_MD); |
| pxa_gpio_mode(GPIO49_nPWE_MD); |
| pxa_gpio_mode(GPIO50_nPIOR_MD); |
| pxa_gpio_mode(GPIO51_nPIOW_MD); |
| pxa_gpio_mode(GPIO85_nPCE_1_MD); |
| pxa_gpio_mode(GPIO54_nPCE_2_MD); |
| pxa_gpio_mode(GPIO79_pSKTSEL_MD); |
| pxa_gpio_mode(GPIO55_nPREG_MD); |
| pxa_gpio_mode(GPIO56_nPWAIT_MD); |
| pxa_gpio_mode(GPIO57_nIOIS16_MD); |
| |
| skt->irq = (skt->nr == 0) ? MAINSTONE_S0_IRQ : MAINSTONE_S1_IRQ; |
| return soc_pcmcia_request_irqs(skt, irqs, ARRAY_SIZE(irqs)); |
| } |
| |
| static void mst_pcmcia_hw_shutdown(struct soc_pcmcia_socket *skt) |
| { |
| soc_pcmcia_free_irqs(skt, irqs, ARRAY_SIZE(irqs)); |
| } |
| |
| static unsigned long mst_pcmcia_status[2]; |
| |
| static void mst_pcmcia_socket_state(struct soc_pcmcia_socket *skt, |
| struct pcmcia_state *state) |
| { |
| unsigned long status, flip; |
| |
| status = (skt->nr == 0) ? MST_PCMCIA0 : MST_PCMCIA1; |
| flip = (status ^ mst_pcmcia_status[skt->nr]) & MST_PCMCIA_nSTSCHG_BVD1; |
| |
| /* |
| * Workaround for STSCHG which can't be deasserted: |
| * We therefore disable/enable corresponding IRQs |
| * as needed to avoid IRQ locks. |
| */ |
| if (flip) { |
| mst_pcmcia_status[skt->nr] = status; |
| if (status & MST_PCMCIA_nSTSCHG_BVD1) |
| enable_irq( (skt->nr == 0) ? MAINSTONE_S0_STSCHG_IRQ |
| : MAINSTONE_S1_STSCHG_IRQ ); |
| else |
| disable_irq( (skt->nr == 0) ? MAINSTONE_S0_STSCHG_IRQ |
| : MAINSTONE_S1_STSCHG_IRQ ); |
| } |
| |
| state->detect = (status & MST_PCMCIA_nCD) ? 0 : 1; |
| state->ready = (status & MST_PCMCIA_nIRQ) ? 1 : 0; |
| state->bvd1 = (status & MST_PCMCIA_nSTSCHG_BVD1) ? 1 : 0; |
| state->bvd2 = (status & MST_PCMCIA_nSPKR_BVD2) ? 1 : 0; |
| state->vs_3v = (status & MST_PCMCIA_nVS1) ? 0 : 1; |
| state->vs_Xv = (status & MST_PCMCIA_nVS2) ? 0 : 1; |
| state->wrprot = 0; /* not available */ |
| } |
| |
| static int mst_pcmcia_configure_socket(struct soc_pcmcia_socket *skt, |
| const socket_state_t *state) |
| { |
| unsigned long power = 0; |
| int ret = 0; |
| |
| switch (state->Vcc) { |
| case 0: power |= MST_PCMCIA_PWR_VCC_0; break; |
| case 33: power |= MST_PCMCIA_PWR_VCC_33; break; |
| case 50: power |= MST_PCMCIA_PWR_VCC_50; break; |
| default: |
| printk(KERN_ERR "%s(): bad Vcc %u\n", |
| __FUNCTION__, state->Vcc); |
| ret = -1; |
| } |
| |
| switch (state->Vpp) { |
| case 0: power |= MST_PCMCIA_PWR_VPP_0; break; |
| case 120: power |= MST_PCMCIA_PWR_VPP_120; break; |
| default: |
| if(state->Vpp == state->Vcc) { |
| power |= MST_PCMCIA_PWR_VPP_VCC; |
| } else { |
| printk(KERN_ERR "%s(): bad Vpp %u\n", |
| __FUNCTION__, state->Vpp); |
| ret = -1; |
| } |
| } |
| |
| if (state->flags & SS_RESET) |
| power |= MST_PCMCIA_RESET; |
| |
| switch (skt->nr) { |
| case 0: MST_PCMCIA0 = power; break; |
| case 1: MST_PCMCIA1 = power; break; |
| default: ret = -1; |
| } |
| |
| return ret; |
| } |
| |
| static void mst_pcmcia_socket_init(struct soc_pcmcia_socket *skt) |
| { |
| } |
| |
| static void mst_pcmcia_socket_suspend(struct soc_pcmcia_socket *skt) |
| { |
| } |
| |
| static struct pcmcia_low_level mst_pcmcia_ops = { |
| .owner = THIS_MODULE, |
| .hw_init = mst_pcmcia_hw_init, |
| .hw_shutdown = mst_pcmcia_hw_shutdown, |
| .socket_state = mst_pcmcia_socket_state, |
| .configure_socket = mst_pcmcia_configure_socket, |
| .socket_init = mst_pcmcia_socket_init, |
| .socket_suspend = mst_pcmcia_socket_suspend, |
| .nr = 2, |
| }; |
| |
| static struct platform_device *mst_pcmcia_device; |
| |
| static int __init mst_pcmcia_init(void) |
| { |
| int ret; |
| |
| mst_pcmcia_device = kmalloc(sizeof(*mst_pcmcia_device), GFP_KERNEL); |
| if (!mst_pcmcia_device) |
| return -ENOMEM; |
| memset(mst_pcmcia_device, 0, sizeof(*mst_pcmcia_device)); |
| mst_pcmcia_device->name = "pxa2xx-pcmcia"; |
| mst_pcmcia_device->dev.platform_data = &mst_pcmcia_ops; |
| |
| ret = platform_device_register(mst_pcmcia_device); |
| if (ret) |
| kfree(mst_pcmcia_device); |
| |
| return ret; |
| } |
| |
| static void __exit mst_pcmcia_exit(void) |
| { |
| /* |
| * This call is supposed to free our mst_pcmcia_device. |
| * Unfortunately platform_device don't have a free method, and |
| * we can't assume it's free of any reference at this point so we |
| * can't free it either. |
| */ |
| platform_device_unregister(mst_pcmcia_device); |
| } |
| |
| fs_initcall(mst_pcmcia_init); |
| module_exit(mst_pcmcia_exit); |
| |
| MODULE_LICENSE("GPL"); |