| # SPDX-License-Identifier: GPL-2.0 |
| # |
| # Makefile for the Linux kernel device drivers. |
| # |
| # 15 Sep 2000, Christoph Hellwig <hch@infradead.org> |
| # Rewritten to use lists instead of if-statements. |
| # |
| |
| obj-y += irqchip/ |
| obj-y += bus/ |
| |
| obj-$(CONFIG_GENERIC_PHY) += phy/ |
| |
| # GPIO must come after pinctrl as gpios may need to mux pins etc |
| obj-$(CONFIG_PINCTRL) += pinctrl/ |
| obj-$(CONFIG_GPIOLIB) += gpio/ |
| obj-y += pwm/ |
| |
| obj-y += pci/ |
| |
| obj-$(CONFIG_PARISC) += parisc/ |
| obj-$(CONFIG_RAPIDIO) += rapidio/ |
| obj-y += video/ |
| obj-y += idle/ |
| |
| # IPMI must come before ACPI in order to provide IPMI opregion support |
| obj-y += char/ipmi/ |
| |
| obj-$(CONFIG_ACPI) += acpi/ |
| obj-$(CONFIG_SFI) += sfi/ |
| # PnP must come after ACPI since it will eventually need to check if acpi |
| # was used and do nothing if so |
| obj-$(CONFIG_PNP) += pnp/ |
| obj-y += amba/ |
| |
| obj-y += clk/ |
| # Many drivers will want to use DMA so this has to be made available |
| # really early. |
| obj-$(CONFIG_DMADEVICES) += dma/ |
| |
| # SOC specific infrastructure drivers. |
| obj-y += soc/ |
| |
| obj-$(CONFIG_VIRTIO) += virtio/ |
| obj-$(CONFIG_XEN) += xen/ |
| |
| # regulators early, since some subsystems rely on them to initialize |
| obj-$(CONFIG_REGULATOR) += regulator/ |
| |
| # reset controllers early, since gpu drivers might rely on them to initialize |
| obj-$(CONFIG_RESET_CONTROLLER) += reset/ |
| |
| # tty/ comes before char/ so that the VT console is the boot-time |
| # default. |
| obj-y += tty/ |
| obj-y += char/ |
| |
| # iommu/ comes before gpu as gpu are using iommu controllers |
| obj-$(CONFIG_IOMMU_SUPPORT) += iommu/ |
| |
| # gpu/ comes after char for AGP vs DRM startup and after iommu |
| obj-y += gpu/ |
| |
| obj-$(CONFIG_CONNECTOR) += connector/ |
| |
| # i810fb and intelfb depend on char/agp/ |
| obj-$(CONFIG_FB_I810) += video/fbdev/i810/ |
| obj-$(CONFIG_FB_INTEL) += video/fbdev/intelfb/ |
| |
| obj-$(CONFIG_PARPORT) += parport/ |
| obj-$(CONFIG_NVM) += lightnvm/ |
| obj-y += base/ block/ misc/ mfd/ nfc/ |
| obj-$(CONFIG_LIBNVDIMM) += nvdimm/ |
| obj-$(CONFIG_DAX) += dax/ |
| obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/ |
| obj-$(CONFIG_NUBUS) += nubus/ |
| obj-y += macintosh/ |
| obj-$(CONFIG_IDE) += ide/ |
| obj-y += scsi/ |
| obj-y += nvme/ |
| obj-$(CONFIG_ATA) += ata/ |
| obj-$(CONFIG_TARGET_CORE) += target/ |
| obj-$(CONFIG_MTD) += mtd/ |
| obj-$(CONFIG_SPI) += spi/ |
| obj-$(CONFIG_SPMI) += spmi/ |
| obj-$(CONFIG_HSI) += hsi/ |
| obj-$(CONFIG_SLIMBUS) += slimbus/ |
| obj-y += net/ |
| obj-$(CONFIG_ATM) += atm/ |
| obj-$(CONFIG_FUSION) += message/ |
| obj-y += firewire/ |
| obj-$(CONFIG_UIO) += uio/ |
| obj-$(CONFIG_VFIO) += vfio/ |
| obj-y += cdrom/ |
| obj-y += auxdisplay/ |
| obj-$(CONFIG_PCCARD) += pcmcia/ |
| obj-$(CONFIG_DIO) += dio/ |
| obj-$(CONFIG_SBUS) += sbus/ |
| obj-$(CONFIG_ZORRO) += zorro/ |
| obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/ |
| obj-$(CONFIG_PARIDE) += block/paride/ |
| obj-$(CONFIG_TC) += tc/ |
| obj-$(CONFIG_UWB) += uwb/ |
| obj-$(CONFIG_USB_PHY) += usb/ |
| obj-$(CONFIG_USB) += usb/ |
| obj-$(CONFIG_USB_SUPPORT) += usb/ |
| obj-$(CONFIG_PCI) += usb/ |
| obj-$(CONFIG_USB_GADGET) += usb/ |
| obj-$(CONFIG_OF) += usb/ |
| obj-$(CONFIG_SERIO) += input/serio/ |
| obj-$(CONFIG_GAMEPORT) += input/gameport/ |
| obj-$(CONFIG_INPUT) += input/ |
| obj-$(CONFIG_RTC_LIB) += rtc/ |
| obj-y += i2c/ i3c/ media/ |
| obj-$(CONFIG_PPS) += pps/ |
| obj-y += ptp/ |
| obj-$(CONFIG_W1) += w1/ |
| obj-y += power/ |
| obj-$(CONFIG_HWMON) += hwmon/ |
| obj-$(CONFIG_THERMAL) += thermal/ |
| obj-$(CONFIG_WATCHDOG) += watchdog/ |
| obj-$(CONFIG_MD) += md/ |
| obj-$(CONFIG_BT) += bluetooth/ |
| obj-$(CONFIG_ACCESSIBILITY) += accessibility/ |
| obj-$(CONFIG_ISDN) += isdn/ |
| obj-$(CONFIG_EDAC) += edac/ |
| obj-$(CONFIG_EISA) += eisa/ |
| obj-$(CONFIG_PM_OPP) += opp/ |
| obj-$(CONFIG_CPU_FREQ) += cpufreq/ |
| obj-$(CONFIG_CPU_IDLE) += cpuidle/ |
| obj-y += mmc/ |
| obj-$(CONFIG_MEMSTICK) += memstick/ |
| obj-$(CONFIG_NEW_LEDS) += leds/ |
| obj-$(CONFIG_INFINIBAND) += infiniband/ |
| obj-$(CONFIG_SGI_SN) += sn/ |
| obj-y += firmware/ |
| obj-$(CONFIG_CRYPTO) += crypto/ |
| obj-$(CONFIG_SUPERH) += sh/ |
| ifndef CONFIG_ARCH_USES_GETTIMEOFFSET |
| obj-y += clocksource/ |
| endif |
| obj-$(CONFIG_DCA) += dca/ |
| obj-$(CONFIG_HID) += hid/ |
| obj-$(CONFIG_PPC_PS3) += ps3/ |
| obj-$(CONFIG_OF) += of/ |
| obj-$(CONFIG_SSB) += ssb/ |
| obj-$(CONFIG_BCMA) += bcma/ |
| obj-$(CONFIG_VHOST_RING) += vhost/ |
| obj-$(CONFIG_VHOST) += vhost/ |
| obj-$(CONFIG_VLYNQ) += vlynq/ |
| obj-$(CONFIG_STAGING) += staging/ |
| obj-y += platform/ |
| |
| obj-$(CONFIG_MAILBOX) += mailbox/ |
| obj-$(CONFIG_HWSPINLOCK) += hwspinlock/ |
| obj-$(CONFIG_REMOTEPROC) += remoteproc/ |
| obj-$(CONFIG_RPMSG) += rpmsg/ |
| obj-$(CONFIG_SOUNDWIRE) += soundwire/ |
| |
| # Virtualization drivers |
| obj-$(CONFIG_VIRT_DRIVERS) += virt/ |
| obj-$(CONFIG_HYPERV) += hv/ |
| |
| obj-$(CONFIG_PM_DEVFREQ) += devfreq/ |
| obj-$(CONFIG_EXTCON) += extcon/ |
| obj-$(CONFIG_MEMORY) += memory/ |
| obj-$(CONFIG_IIO) += iio/ |
| obj-$(CONFIG_VME_BUS) += vme/ |
| obj-$(CONFIG_IPACK_BUS) += ipack/ |
| obj-$(CONFIG_NTB) += ntb/ |
| obj-$(CONFIG_FMC) += fmc/ |
| obj-$(CONFIG_POWERCAP) += powercap/ |
| obj-$(CONFIG_MCB) += mcb/ |
| obj-$(CONFIG_PERF_EVENTS) += perf/ |
| obj-$(CONFIG_RAS) += ras/ |
| obj-$(CONFIG_THUNDERBOLT) += thunderbolt/ |
| obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/ |
| obj-y += hwtracing/intel_th/ |
| obj-$(CONFIG_STM) += hwtracing/stm/ |
| obj-$(CONFIG_ANDROID) += android/ |
| obj-$(CONFIG_NVMEM) += nvmem/ |
| obj-$(CONFIG_FPGA) += fpga/ |
| obj-$(CONFIG_FSI) += fsi/ |
| obj-$(CONFIG_TEE) += tee/ |
| obj-$(CONFIG_MULTIPLEXER) += mux/ |
| obj-$(CONFIG_UNISYS_VISORBUS) += visorbus/ |
| obj-$(CONFIG_SIOX) += siox/ |
| obj-$(CONFIG_GNSS) += gnss/ |