Input: atmel_mxt_ts - disable interrupt for 50ms after reset
The CHG/interrupt line is momentarily set (approximately 100 ms) as an
input after power-up or reset for diagnostic purposes. This may cause
spurious interrupts, so disable interrupt handler during this period.
Signed-off-by: Nick Dyer <nick.dyer@itdev.co.uk>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/drivers/input/touchscreen/atmel_mxt_ts.c b/drivers/input/touchscreen/atmel_mxt_ts.c
index 08d9a09..d36da65 100644
--- a/drivers/input/touchscreen/atmel_mxt_ts.c
+++ b/drivers/input/touchscreen/atmel_mxt_ts.c
@@ -1098,7 +1098,9 @@
struct device *dev = &data->client->dev;
int ret = 0;
- dev_info(dev, "Resetting chip\n");
+ dev_info(dev, "Resetting device\n");
+
+ disable_irq(data->irq);
reinit_completion(&data->reset_completion);
@@ -1106,6 +1108,11 @@
if (ret)
return ret;
+ /* Ignore CHG line for 100ms after reset */
+ msleep(100);
+
+ enable_irq(data->irq);
+
ret = mxt_wait_for_completion(data, &data->reset_completion,
MXT_RESET_TIMEOUT);
if (ret)