ioc3-eth/meth: Move the SGI drivers

Move the SGI drivers into drivers/net/ethernet/sgi/ and make the
necessary Kconfig and Makefile changes.

CC: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/sgi/Kconfig b/drivers/net/ethernet/sgi/Kconfig
new file mode 100644
index 0000000..3098594
--- /dev/null
+++ b/drivers/net/ethernet/sgi/Kconfig
@@ -0,0 +1,34 @@
+#
+# SGI device configuration
+#
+
+config NET_VENDOR_SGI
+	bool "SGI devices"
+	depends on (PCI && SGI_IP27) || SGI_IP32
+	---help---
+	  If you have a network (Ethernet) card belonging to this class, say Y
+	  and read the Ethernet-HOWTO, available from
+	  <http://www.tldp.org/docs.html#howto>.
+
+	  Note that the answer to this question doesn't directly affect the
+	  kernel: saying N will just cause the configurator to skip all
+	  the questions about SGI devices. If you say Y, you will be asked for
+	  your specific card in the following questions.
+
+if NET_VENDOR_SGI
+
+config SGI_IOC3_ETH
+	bool "SGI IOC3 Ethernet"
+	depends on PCI && SGI_IP27
+	select CRC32
+	select MII
+	---help---
+	  If you have a network (Ethernet) card of this type, say Y and read
+	  the Ethernet-HOWTO, available from
+	  <http://www.tldp.org/docs.html#howto>.
+
+config SGI_O2MACE_ETH
+	tristate "SGI O2 MACE Fast Ethernet support"
+	depends on SGI_IP32=y
+
+endif # NET_VENDOR_SGI