iwlwifi: pcie: clean RFKILL interrupt in AMPG
Newer firmware don't clean the RFKILL interrupt in APMG, do
it in driver instead.
If we forget to do so, we can't send HCMD to firmware while
the NIC is in RFKILL state.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-prph.h b/drivers/net/wireless/iwlwifi/iwl-prph.h
index ff8cc75..a70c7b9 100644
--- a/drivers/net/wireless/iwlwifi/iwl-prph.h
+++ b/drivers/net/wireless/iwlwifi/iwl-prph.h
@@ -97,6 +97,8 @@
#define APMG_PCIDEV_STT_VAL_L1_ACT_DIS (0x00000800)
+#define APMG_RTC_INT_STT_RFKILL (0x10000000)
+
/* Device system time */
#define DEVICE_SYSTEM_TIME_REG 0xA0206C
diff --git a/drivers/net/wireless/iwlwifi/pcie/trans.c b/drivers/net/wireless/iwlwifi/pcie/trans.c
index bad95d2..e66c7e3 100644
--- a/drivers/net/wireless/iwlwifi/pcie/trans.c
+++ b/drivers/net/wireless/iwlwifi/pcie/trans.c
@@ -220,6 +220,9 @@
iwl_set_bits_prph(trans, APMG_PCIDEV_STT_REG,
APMG_PCIDEV_STT_VAL_L1_ACT_DIS);
+ /* Clear the interrupt in APMG if the NIC is in RFKILL */
+ iwl_write_prph(trans, APMG_RTC_INT_STT_REG, APMG_RTC_INT_STT_RFKILL);
+
set_bit(STATUS_DEVICE_ENABLED, &trans_pcie->status);
out: