video: da8xx-fb rev2: fix disabling of palette completion interrupt
Writing '1' to particular bit of IRQENABLE_CLEAR register disables the
corresponding interrupt on revision 2 LCDC. This register was wrongly
configured to disable all previous enabled interrupts instead of
disabling only palette completion interrupt. Patch fixes it by clearing
only palette completion interrupt bit.
Signed-off-by: Manjunathappa, Prakash <prakash.pm@ti.com>
Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
diff --git a/drivers/video/da8xx-fb.c b/drivers/video/da8xx-fb.c
index 034e182..7264aa3 100644
--- a/drivers/video/da8xx-fb.c
+++ b/drivers/video/da8xx-fb.c
@@ -716,7 +716,6 @@
{
struct da8xx_fb_par *par = arg;
u32 stat = lcdc_read(LCD_MASKED_STAT_REG);
- u32 reg_int;
if ((stat & LCD_SYNC_LOST) && (stat & LCD_FIFO_UNDERFLOW)) {
lcd_disable_raster();
@@ -733,10 +732,8 @@
lcdc_write(stat, LCD_MASKED_STAT_REG);
- /* Disable PL completion inerrupt */
- reg_int = lcdc_read(LCD_INT_ENABLE_CLR_REG) |
- (LCD_V2_PL_INT_ENA);
- lcdc_write(reg_int, LCD_INT_ENABLE_CLR_REG);
+ /* Disable PL completion interrupt */
+ lcdc_write(LCD_V2_PL_INT_ENA, LCD_INT_ENABLE_CLR_REG);
/* Setup and start data loading mode */
lcd_blit(LOAD_DATA, par);