arm64: dts: qcom: pmi8994: add interrupt controller properties
Add interrupt controller properties now that spmi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.
This change was not tested on any hardware but the same change was
tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with
no issues.
Signed-off-by: Brian Masney <masneyb@onstation.org>
Reviewed-by: Stephen Boyd <sboyd@kernel.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/arch/arm64/boot/dts/qcom/pmi8994.dtsi b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
index dae1cdc..3aee10e 100644
--- a/arch/arm64/boot/dts/qcom/pmi8994.dtsi
+++ b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
@@ -15,16 +15,8 @@
reg = <0xc000>;
gpio-controller;
#gpio-cells = <2>;
- interrupts = <2 0xc0 0 IRQ_TYPE_NONE>,
- <2 0xc1 0 IRQ_TYPE_NONE>,
- <2 0xc2 0 IRQ_TYPE_NONE>,
- <2 0xc3 0 IRQ_TYPE_NONE>,
- <2 0xc4 0 IRQ_TYPE_NONE>,
- <2 0xc5 0 IRQ_TYPE_NONE>,
- <2 0xc6 0 IRQ_TYPE_NONE>,
- <2 0xc7 0 IRQ_TYPE_NONE>,
- <2 0xc8 0 IRQ_TYPE_NONE>,
- <2 0xc9 0 IRQ_TYPE_NONE>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
};
};