vti: don't allow to add the same tunnel twice
Before the patch, it was possible to add two times the same tunnel:
ip l a vti1 type vti remote 10.16.0.121 local 10.16.0.249 key 41
ip l a vti2 type vti remote 10.16.0.121 local 10.16.0.249 key 41
It was possible, because ip_tunnel_newlink() calls ip_tunnel_find() with the
argument dev->type, which was set only later (when calling ndo_init handler
in register_netdevice()). Let's set this type in the setup handler, which is
called before newlink handler.
Introduced by commit b9959fd3b0fa ("vti: switch to new ip tunnel code").
CC: Cong Wang <amwang@redhat.com>
CC: Steffen Klassert <steffen.klassert@secunet.com>
Signed-off-by: Nicolas Dichtel <nicolas.dichtel@6wind.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv4/ip_vti.c b/net/ipv4/ip_vti.c
index 687ddef..afcee51 100644
--- a/net/ipv4/ip_vti.c
+++ b/net/ipv4/ip_vti.c
@@ -337,6 +337,7 @@
static void vti_tunnel_setup(struct net_device *dev)
{
dev->netdev_ops = &vti_netdev_ops;
+ dev->type = ARPHRD_TUNNEL;
ip_tunnel_setup(dev, vti_net_id);
}
@@ -348,7 +349,6 @@
memcpy(dev->dev_addr, &iph->saddr, 4);
memcpy(dev->broadcast, &iph->daddr, 4);
- dev->type = ARPHRD_TUNNEL;
dev->hard_header_len = LL_MAX_HEADER + sizeof(struct iphdr);
dev->mtu = ETH_DATA_LEN;
dev->flags = IFF_NOARP;