[PATCH] libata: fix ata_qc_issue() error handling
When ata_qc_issue() fails, the qc might have been dma mapped or not.
So, performing only ata_qc_free() results in dma map leak. This patch
makes ata_qc_issue() mark dma map flags correctly on failure and calls
ata_qc_complete() after ata_qc_issue() fails.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
diff --git a/drivers/scsi/libata-core.c b/drivers/scsi/libata-core.c
index 15df633..43a2328 100644
--- a/drivers/scsi/libata-core.c
+++ b/drivers/scsi/libata-core.c
@@ -1125,8 +1125,10 @@
qc->private_data = &wait;
qc->complete_fn = ata_qc_complete_internal;
- if (ata_qc_issue(qc))
- goto issue_fail;
+ if (ata_qc_issue(qc)) {
+ qc->err_mask = AC_ERR_OTHER;
+ ata_qc_complete(qc);
+ }
spin_unlock_irqrestore(&ap->host_set->lock, flags);
@@ -1155,11 +1157,6 @@
ata_qc_free(qc);
return err_mask;
-
- issue_fail:
- ata_qc_free(qc);
- spin_unlock_irqrestore(&ap->host_set->lock, flags);
- return AC_ERR_OTHER;
}
/**
@@ -3687,10 +3684,10 @@
if (ata_should_dma_map(qc)) {
if (qc->flags & ATA_QCFLAG_SG) {
if (ata_sg_setup(qc))
- goto err_out;
+ goto sg_err;
} else if (qc->flags & ATA_QCFLAG_SINGLE) {
if (ata_sg_setup_one(qc))
- goto err_out;
+ goto sg_err;
}
} else {
qc->flags &= ~ATA_QCFLAG_DMAMAP;
@@ -3703,7 +3700,8 @@
return ap->ops->qc_issue(qc);
-err_out:
+sg_err:
+ qc->flags &= ~ATA_QCFLAG_DMAMAP;
return -1;
}
diff --git a/drivers/scsi/libata-scsi.c b/drivers/scsi/libata-scsi.c
index ce3fe92..c496309 100644
--- a/drivers/scsi/libata-scsi.c
+++ b/drivers/scsi/libata-scsi.c
@@ -1322,8 +1322,10 @@
goto early_finish;
/* select device, send command to hardware */
- if (ata_qc_issue(qc))
- goto err_did;
+ if (ata_qc_issue(qc)) {
+ qc->err_mask |= AC_ERR_OTHER;
+ ata_qc_complete(qc);
+ }
VPRINTK("EXIT\n");
return;