qed: Correct slowpath interrupt scheme
When using INTa, ISR might be called before device is configured
for INTa [E.g., due to other device asserting the shared interrupt line],
in which case the ISR would read the SISR registers that shouldn't be
read unless HW is already configured for INTa. This might break interrupts
later on. There's also an MSI-X issue due to this difference, although
it's mostly theoretical.
This patch changes the initialization order, calling request_irq() for the
slowpath interrupt only after the chip is configured for working
in the preferred interrupt mode.
Signed-off-by: Sudarsana Kalluru <Sudarsana.Kalluru@qlogic.com>
Signed-off-by: Manish Chopra <manish.chopra@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_int.h b/drivers/net/ethernet/qlogic/qed/qed_int.h
index 16b5751..51e0b09 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_int.h
+++ b/drivers/net/ethernet/qlogic/qed/qed_int.h
@@ -169,10 +169,14 @@
int *p_iov_blks);
/**
- * @file
+ * @brief qed_int_disable_post_isr_release - performs the cleanup post ISR
+ * release. The API need to be called after releasing all slowpath IRQs
+ * of the device.
*
- * @brief Interrupt handler
+ * @param cdev
+ *
*/
+void qed_int_disable_post_isr_release(struct qed_dev *cdev);
#define QED_CAU_DEF_RX_TIMER_RES 0
#define QED_CAU_DEF_TX_TIMER_RES 0
@@ -366,10 +370,11 @@
* @param p_hwfn
* @param p_ptt
* @param int_mode
+ *
+ * @return int
*/
-void qed_int_igu_enable(struct qed_hwfn *p_hwfn,
- struct qed_ptt *p_ptt,
- enum qed_int_mode int_mode);
+int qed_int_igu_enable(struct qed_hwfn *p_hwfn, struct qed_ptt *p_ptt,
+ enum qed_int_mode int_mode);
/**
* @brief - Initialize CAU status block entry