PCI: designware: Make "num-lanes" an optional DT property
Currently "num-lanes" is read in dw_pcie_host_init(), but it is only used
if we call dw_pcie_setup_rc() while bringing up the link. If the link has
already been brought up by firmware, we need not call dw_pcie_setup_rc(),
and "num-lanes" is unnecessary.
Only complain about "num-lanes" if we actually need it and we didn't find a
valid value.
[bhelgaas: changelog]
Signed-off-by: Gabriele Paoloni <gabriele.paoloni@huawei.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
diff --git a/drivers/pci/host/pcie-designware.c b/drivers/pci/host/pcie-designware.c
index b77535f..fb89ca2 100644
--- a/drivers/pci/host/pcie-designware.c
+++ b/drivers/pci/host/pcie-designware.c
@@ -534,10 +534,9 @@
}
}
- if (of_property_read_u32(np, "num-lanes", &pp->lanes)) {
- dev_err(pp->dev, "Failed to parse the number of lanes\n");
- return -EINVAL;
- }
+ ret = of_property_read_u32(np, "num-lanes", &pp->lanes);
+ if (ret)
+ pp->lanes = 0;
if (IS_ENABLED(CONFIG_PCI_MSI)) {
if (!pp->ops->msi_host_init) {
@@ -814,6 +813,9 @@
case 8:
val |= PORT_LINK_MODE_8_LANES;
break;
+ default:
+ dev_err(pp->dev, "num-lanes %u: invalid value\n", pp->lanes);
+ return;
}
dw_pcie_writel_rc(pp, val, PCIE_PORT_LINK_CONTROL);