iwlwifi: pcie: Control access to the NIC's PM registers via iwl_cfg
Allow a cleaner way to access those hw-dependent registers,
instead of using the product family type etc.
Signed-off-by: Avri Altman <avri.altman@intel.com>
Reviewed-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/pcie/trans.c b/drivers/net/wireless/iwlwifi/pcie/trans.c
index a341ed9..dd1b90b 100644
--- a/drivers/net/wireless/iwlwifi/pcie/trans.c
+++ b/drivers/net/wireless/iwlwifi/pcie/trans.c
@@ -182,6 +182,9 @@
static void iwl_pcie_set_pwr(struct iwl_trans *trans, bool vaux)
{
+ if (!trans->cfg->apmg_not_supported)
+ return;
+
if (vaux && pci_pme_capable(to_pci_dev(trans->dev), PCI_D3cold))
iwl_set_bits_mask_prph(trans, APMG_PS_CTRL_REG,
APMG_PS_CTRL_VAL_PWR_SRC_VAUX,
@@ -315,7 +318,7 @@
* bits do not disable clocks. This preserves any hardware
* bits already set by default in "CLK_CTRL_REG" after reset.
*/
- if (trans->cfg->device_family != IWL_DEVICE_FAMILY_8000) {
+ if (!trans->cfg->apmg_not_supported) {
iwl_write_prph(trans, APMG_CLK_EN_REG,
APMG_CLK_VAL_DMA_CLK_RQT);
udelay(20);
@@ -515,8 +518,7 @@
spin_unlock(&trans_pcie->irq_lock);
- if (trans->cfg->device_family != IWL_DEVICE_FAMILY_8000)
- iwl_pcie_set_pwr(trans, false);
+ iwl_pcie_set_pwr(trans, false);
iwl_op_mode_nic_config(trans->op_mode);
@@ -1063,7 +1065,7 @@
iwl_pcie_rx_stop(trans);
/* Power-down device's busmaster DMA clocks */
- if (trans->cfg->device_family != IWL_DEVICE_FAMILY_8000) {
+ if (!trans->cfg->apmg_not_supported) {
iwl_write_prph(trans, APMG_CLK_DIS_REG,
APMG_CLK_VAL_DMA_CLK_RQT);
udelay(5);
@@ -1160,8 +1162,7 @@
*/
iwl_trans_pcie_tx_reset(trans);
- if (trans->cfg->device_family != IWL_DEVICE_FAMILY_8000)
- iwl_pcie_set_pwr(trans, true);
+ iwl_pcie_set_pwr(trans, true);
}
static int iwl_trans_pcie_d3_resume(struct iwl_trans *trans,
@@ -1199,8 +1200,7 @@
return ret;
}
- if (trans->cfg->device_family != IWL_DEVICE_FAMILY_8000)
- iwl_pcie_set_pwr(trans, false);
+ iwl_pcie_set_pwr(trans, false);
iwl_trans_pcie_tx_reset(trans);