pcmcia: do not use io_req_t after call to pcmcia_request_io()
After pcmcia_request_io(), do not make use of the values stored in
io_req_t, but instead use those found in struct pcmcia_device->resource[].
CC: netdev@vger.kernel.org
CC: linux-wireless@vger.kernel.org
CC: linux-ide@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: laforge@gnumonks.org
CC: linux-mtd@lists.infradead.org
CC: alsa-devel@alsa-project.org
CC: linux-serial@vger.kernel.org
Acked-by: Marcel Holtmann <marcel@holtmann.org> (for drivers/bluetooth/)
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/pcmcia/xirc2ps_cs.c b/drivers/net/pcmcia/xirc2ps_cs.c
index e3a85ce..034920b 100644
--- a/drivers/net/pcmcia/xirc2ps_cs.c
+++ b/drivers/net/pcmcia/xirc2ps_cs.c
@@ -877,13 +877,13 @@
* the base address of the ethernet port (BasePort1) is written
* to the BAR registers of the modem.
*/
- err = pcmcia_write_config_byte(link, CISREG_IOBASE_0,
- link->io.BasePort2 & 0xff);
+ err = pcmcia_write_config_byte(link, CISREG_IOBASE_0, (u8)
+ link->resource[1]->start & 0xff);
if (err)
goto config_error;
err = pcmcia_write_config_byte(link, CISREG_IOBASE_1,
- (link->io.BasePort2 >> 8) & 0xff);
+ (link->resource[1]->start >> 8) & 0xff);
if (err)
goto config_error;
@@ -907,7 +907,7 @@
* part.
*/
writeb(0x47, local->dingo_ccr + CISREG_COR);
- ioaddr = link->io.BasePort1;
+ ioaddr = link->resource[0]->start;
writeb(ioaddr & 0xff , local->dingo_ccr + CISREG_IOBASE_0);
writeb((ioaddr >> 8)&0xff , local->dingo_ccr + CISREG_IOBASE_1);
@@ -954,7 +954,7 @@
/* we can now register the device with the net subsystem */
dev->irq = link->irq;
- dev->base_addr = link->io.BasePort1;
+ dev->base_addr = link->resource[0]->start;
if (local->dingo)
do_reset(dev, 1); /* a kludge to make the cem56 work */